Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
Electronics Forum | Mon Mar 20 15:41:00 EDT 2023 | oclsc
Hallo SMTnet. We have just bought a VXS Air 3.2/634 Rehm reflow oven. We are wondering why the conveyor chain in the oven is still running two days after the "Auto OFF" precedure/program has been activated. In this case the oven set to "Auto Off" Fr
Electronics Forum | Tue Mar 21 11:57:27 EDT 2023 | stephendo
Or after a preset amount of time. Maybe the oven has a setting somewhere that is not set propely.
Electronics Forum | Mon Mar 20 22:08:24 EDT 2023 | tey422
For reflow oven to "auto off" it has to go through the cool down; it should be off went the cool off temperature is reached. Perhaps you need to 1st check if something prevent the oven reach the cool off temp (both hardware & software).
Electronics Forum | Tue Jun 12 23:25:29 EDT 2001 | chinaren
As you know there will be a lot of residues(such as rosin) left especialy on the peak zone and cooling zone of reflow oven after reflow soldering in a time. who use one kind of effective liquor or effective method to clean the residues ?
Electronics Forum | Wed Jun 13 13:34:14 EDT 2001 | Slap Nutz
One Tequila, Two Tequila, Three Tequila, Floor et vous, DaveF?
Electronics Forum | Wed Jun 13 17:17:57 EDT 2001 | medernach
I use BioAct SC-10 and it seems to work pretty well. The best bet is to contact your solder paste manufacturer and ask them for a recommended cleaning solvent for the flux residues... Regards, Justin
Electronics Forum | Wed Jun 13 21:33:34 EDT 2001 | davef
Todays crazy idea?! (environmental safe) February 22, 2001 05:33 AM Mattias Andersson [http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&&Message_ID=5343&_#Message5343] Turning things just a bit, our working theory is: burnt flux
Electronics Forum | Thu Mar 21 13:23:15 EDT 2013 | cyber_wolf
Stay away from used Nitrogen ovens unless you have a specific need for it. The flux management is a pain in the arse to clean. I don't care how simple they claim it is.
Electronics Forum | Fri Apr 11 13:58:32 EDT 2014 | proy
Have an older reflow oven which I need to clean up collected flux residues from the chain, mesh, intake/exhaust areas, slides etc heavy brown dust, likely water soluble residues, lots of polymerized brown resin as well.
.gif)
