Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Tue Feb 11 13:22:22 EST 2020 | rgduval
Sebas, I suspect that your finding of needing the fillet for the card to work is a false finding. One that I dealt with for many years in assembly. As a bottom terminated device, a fillet to the side terminals of the device is not required. Adequ
Electronics Forum | Thu Feb 20 07:48:16 EST 2020 | benreben
Hello, The oven profil is not the solution! The only solution for the solder mount on the side is to put gel flux on the side of qfn and make a second travel in reflow . The flux remove oxyde from the copper that is not tinned and the solder is able
Electronics Forum | Tue Feb 11 11:40:21 EST 2020 | emeto
Sebas, on your profile you have listed U2, U101, U102 and I was wondering if the questioned part is one of them. I attach a typical profile specs - you should follow the one for your paste. In the one you attached the slope is too fast, soak is prob
Electronics Forum | Thu Sep 18 11:07:39 EDT 2003 | donbell
SR. Tech: I have worked with Omniflo 7 and 10 ovens for many years. I purchased several 10 zone ovens in '98 when I worked for Ericsson. Here are some of my experinces with Electrovert Omniflo ovens; Yes, you can expect to run the conveyor speed a
Electronics Forum | Fri Jun 23 12:21:29 EDT 2017 | rgduval
I'm going to guess that you've tried Speedline with no success. They're awfully annoying about their older machines. Things to check: - Thermistor for the zone working properly? - Opto for the zone working correctly? - Heaters working correctly? -
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Tue Oct 05 13:43:58 EDT 2004 | cyber_wolf
Try this goofdaddy out. http://www.reflow-ovens.com/
Electronics Forum | Mon Oct 04 16:47:15 EDT 2004 | dgjjr
I'm looking for Quad ZCR 941 parts outside of the Tyco pipeline. Anyone know of a good reseller with access to Quad oven parts? dj
Electronics Forum | Sun Apr 10 14:08:29 EDT 2005 | greg
Hi there I have a question about reflow oven for Pb-free technology. I've noticed that some of the manufactures offer reflow ovens with short (26-30 lenght in cm) heat zones others offer longer more then 30 cm. So there are ovens with total heat len
winsouce.jpg)