Electronics Forum | Thu Dec 22 06:46:01 EST 2011 | rameshraja
Dear All, We are doing PCBA's manufacturing,Inprocess we are doing manual soldering, reflow and wave soldering process, As per ISO-7.5.2 Process validation ( Special process ) Soldering process is considered as an special process, hence in order to
Electronics Forum | Wed Feb 22 12:40:41 EST 2006 | russ
Here are some of the things we had to do when we had to validate process. Incoming voltage Air pressure squeegee speed placement accuracy oven stability
Electronics Forum | Thu Feb 23 02:46:16 EST 2006 | INGE
It isn't an FDA validation. I think Steve has centered the problem. I have already defined all the steps and all the procedures of the process, but now I must run X boards, Y times, through each piece of equipment (as he said before); the question is
Electronics Forum | Wed Feb 22 12:19:49 EST 2006 | Dirka Jihabi
I worked for a EMS who makes Medical Device Electronics, and yeah, the FDA's methodology for validation is a complete cluster-fudge! They did it on the principle of...does the shop air going into your equipment REALLY 80 PSI...or is there REALLY 220
Electronics Forum | Wed Dec 15 16:17:30 EST 2010 | rgduval
Sounds like there may be a people problem somewhere in your process. We have a couple of checks set up to aid with capturing first article issues. First, of course, the kit is checked against the BOM to ensure that all of the parts match. Then, we
Electronics Forum | Thu Feb 23 11:40:45 EST 2006 | billyd
My company is looking to run some small validation cards to verify our Pb free process for potential customers. Basocally, we'd like to print a small card, place some components, say 0402 to a small BGA, maybe some thru-hole stuff, and reflow it. So
Electronics Forum | Mon May 24 15:50:11 EDT 2004 | Rob
hi all What do you think about soldering pb-free in reflow oven (air) lenght 1,7m (5 zones top,bottom) with max zone temp. 300C? Do you think that this process will be stable? Our max PCb dimension 260x260 mm. When i compare different oven producer t
Electronics Forum | Fri Jan 19 07:26:45 EST 2007 | Richard-magictek Tech
kindly send me your reflow profile ---and also the PCB lay out i shall able to determine your process flow on speed....and glue application i can be reach at this email- rdm@magictek.com.cn my web site is ;www.magictek.com.tw we are furance maker w
Electronics Forum | Sat Jan 06 05:17:16 EST 2007 | shrikant_borkar
Hi. How one Can suggest you unless your Involment in your Process? Check Following Points and also Is Reflow Temp - Profile is as Per Glue Mfg. Requirment Are Glue Dot in Sysmetricl Position? Is glue sufficient , below IC to hold ? please visit th
Electronics Forum | Fri Mar 15 08:25:42 EDT 2013 | torch
looking for a bit of advice really, our current reflow oven (surfair 510) is in the process of slowly dieing so we are in the market for a replacement. I havent followed technologies on ovens for a while but im looking for something that is low to m
