Electronics Forum | Thu Jun 10 15:46:56 EDT 1999 | Chrys Shea
| Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like point-
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
Electronics Forum | Tue Jun 15 16:37:17 EDT 1999 | Philip Kazmierowicz
| | | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like
Electronics Forum | Sat Jun 12 16:45:48 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Sat Jun 12 17:41:13 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Mon Apr 11 06:37:59 EDT 2005 | amstech
As long as you have a continuous profile with required soak and dwell periods, the zone lengths do not matter. For lead free, usually ramp to peak is preffered.that is with minimum soak (you can not avoid soak anyway. You can achieve the profiles irr
Electronics Forum | Mon May 24 16:45:44 EDT 2004 | Bob
BTU as well as most oven manufactuers have great products. If they fit what your looking for and can give you good support(preferably local) then you should not really see any quality problems with their products. With the oven max temperature of 300
Electronics Forum | Fri Apr 02 09:41:45 EST 2004 | mattkehoe
We are in the process of purchasing a mole for our reflow oven. We've only looked at one model and it works well however, my accountablilty partners desire that we look at other options before we make the decision. Looking at about 3k. Opinions from
Electronics Forum | Fri Apr 02 11:23:44 EST 2004 | pjc
ECD has some advantages in terms of upgrade path. Once you buy the ECD SuperM.O.L.E., you can use it in a OvenRIDER, WaveRIDER and ReworkRIDER products. The OR, WR and RR are solder machine management devices for solder process control. Where profile
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
winsouce.jpg)