Electronics Forum | Wed Jan 07 13:17:56 EST 2004 | James
We currently have 2 HVA 102 conceptronic reflow ovens. I ran 2 profiles on the 2 seperate machines. One of the oven ran 7 degrees lower than the other oven. I checked all the fans and they seem to running fine. I get no warning on the monitors.
Electronics Forum | Thu Jan 08 16:21:05 EST 2004 | Bill
James: The ovens can be calibrated to help get this a little closer. In the computer box are 3 cards (alike) attached to the motherboard. They are called IPS-7 cards. On these cards are 2 potentiometers to calibrate the T/Cs for the heat zones. There
Electronics Forum | Tue Mar 01 09:32:49 EST 2005 | TDS
I have a conceptronic HVA70 in Ohio for sale. If interested please email me. scott@tritecsales.com
Electronics Forum | Fri Feb 25 16:16:01 EST 2005 | pjc
Here are some 5 zones models to look for: Electrovert OmniFlo5 Conceptronic HVA70 BTU VIP70 Vitronics SMR or XPM 520 Heller 1088 (4 zone)
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
Electronics Forum | Thu Jan 08 16:43:43 EST 2004 | Dean
Unless your machine (internal) thermocouples are each calibrated and compensated no two machines will deliver eactly the same results. Here are your challenges: 1. Data acquisition equipment A-D converter errors 2. PCB measurement thermocouple (t
Electronics Forum | Fri Oct 27 09:42:12 EDT 2000 | Daniel Carlsson
I wonder if anyone have experience from using a fairly new reflow oven and would like to share your toughts (advantages or disadvantages) with me. I�m especially interested in: Conceptronic, Electrovert, ERSA, Heller, Quad, Rehm, Seho, SMT or Vitroni
Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta
Electronics Forum | Fri Jun 23 12:21:29 EDT 2017 | rgduval
I'm going to guess that you've tried Speedline with no success. They're awfully annoying about their older machines. Things to check: - Thermistor for the zone working properly? - Opto for the zone working correctly? - Heaters working correctly? -
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
