Electronics Forum | Fri Sep 25 10:28:08 EDT 2009 | leemeyer
Are you running Q-soft software or is this an older machine running central controller ? Do you have seperate profiles set up for 0603 caps and 0603 resistors or just one profile for all 0603 parts. It sounds to me that you might be scanning to low a
Electronics Forum | Sat Sep 22 09:07:56 EDT 2001 | davef
Back-stepping a bit. If a profile is being used to: * Set-up the oven for a new product or trouble-shooting process, the profile should be taken with a solid contact to a solder connection. * Monitoring on-going stable and in-control process that re
Electronics Forum | Tue Feb 19 12:28:26 EST 2019 | slthomas
Presumably you're talking about lead free, but you don't say. Heller can probably provide you with a starting point, as rob has already pointed out, but you do need to develop the capability to perform profiling yourself. That oven should have ECD
Electronics Forum | Tue Sep 09 12:05:44 EDT 2008 | tonyamenson
First and fore most is to find your paste manufacturer spec sheets. Read it over several times and let it all sink in. Then call them with questions as they want to keep your business so their engineers want to help you use their product. I assume y
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Tue Feb 19 08:41:02 EST 2019 | prasanth
dear experts, i want your suggestion for getting a profile in Heller 1707 mk iii series re-flow machine ,its 7 zone machine recently we had a solder ability issues , so pls guide me ,how to set rts profile parameters
Electronics Forum | Tue Feb 19 10:50:13 EST 2019 | rgduval
Call Heller directly, and give them the oven, and relative thermal density of the board, as well as the solder paste that you're using. They'll be able to give you a baseline profile to start from (both RTS and RSS). Otherwise, use a thermocouple p
Electronics Forum | Wed Feb 20 11:40:31 EST 2019 | bmalhi
Heller Oven comes with a profile pre-loaded so you can start there. RTS = Ramp to Spike. Basically a straight line from preheat to spike. Also known as “Tent” profile RSS = Ramp Soak Spike. This one creates a flat line around 150-180 degrees on th
Electronics Forum | Tue Aug 13 13:46:54 EDT 2002 | soupatech
Hello again.... I have been reading up on profiles and how to set them up for different results. I now have an upcomming job with some strict guidlines on reflow. I was wondering... if I were to email a pic of my desired profile could someone out the
Electronics Forum | Tue Sep 02 13:30:11 EDT 2008 | hermes
Try this. Basic reflow profile build up and explanation of its parts: ramp-up, soak or no soak, peak, cooling. Good starting point.