Electronics Forum | Wed Jul 16 03:03:36 EDT 2008 | lococost
if it's still under warranty, why dont you let essemtec fix it?
Electronics Forum | Tue Jul 15 12:11:22 EDT 2008 | gabriella
Hello, I would remove a link, if I was you. As I can hear from you their support is not good anyway(if it is in warranty, they should help you, wright?).
Electronics Forum | Tue Jul 15 13:42:36 EDT 2008 | dwelch123
Ed, sounds like your tech. is full of *hit. He must be fatter and lazier than me!! I'd call Essemtec and make sure that his statement is correct, and if it's true, Gabriella is right. Have a good one bud.
Electronics Forum | Thu Jul 24 00:35:43 EDT 2008 | chip_flip
I would remove enough links to get the tensioning assembly back where you have room for adjustment again. I would have to agree that if the machine is still under warranty you should have Essemtec correct the issue.
Electronics Forum | Thu Jul 17 22:33:31 EDT 2008 | gdzuber
Greetings, I have to agree with others here. If the system is under warranty get them back in and have them fix it. I work for another oven manufacturer and we would take care of this under warranty. If it is a design defect we might fix it for free
Electronics Forum | Tue Jul 15 09:02:09 EDT 2008 | ehess
Has anyone using these ovens had any problems with the chain (flat) belt slipping? I suggested to the tech we remove a link in the flat chain, and he responded it would make it out of warranty. It's the same type of chain flat belt as most wash and
Electronics Forum | Thu Sep 13 15:09:07 EDT 2018 | reckless
So it took me a few months to figure out the compact reflow oven market. I bought the following ovens: Heller 1500EXL Essemtec RO300FC-C - QTY 2 DDM Novastar Gold Flow - Desktop DDM Novastar 1800HT - Conveyor Zevatech 5 zone oven T962C benchtop ove
Electronics Forum | Fri Mar 11 13:03:08 EST 2022 | poly
I've just bought the pick and place machines (universal Genesis GX11 and GC30) and oven (RO300fc-c) but I am confused about printers. I've put in an offer for an MPM Accela (2006 or 2008) but I'm not sure if it's a good idea / deal. It's being sold i
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Wed Jun 20 12:55:29 EDT 2018 | reckless
Which compact oven manufacturer makes a better product? Essemtec or DDM? The Essemtec units look the same as Manncorp. I have found 2 RO300FC's and a Novastar 1800. The 1800 looks like it hits a higher temperature but not sure if its needed to go
