Electronics Forum | Thu Jan 19 13:15:53 EST 2012 | waveroom
As a distributor we sell very little SN100C for SMT, we sell far more SAC305 for SMT. The higher temperatures are the reasons.
Electronics Forum | Thu Jan 19 16:38:39 EST 2012 | dyoungquist
We are not using SN100C in our reflow process but I know the type of flux made a big difference with our SAC305 solder. We started out using no-clean flux in our SAC305 paste and were having some issues. We then switched over to a water soluble flu
Electronics Forum | Tue Jan 17 21:40:08 EST 2012 | gaz
I'm testing SN100C, and with our 5 zone oven I seem to be able to fix one issue by changing the profile, but that might introduce a new problem. Some profiles work very well on most components, but have issues on other components. These are usually 0
Electronics Forum | Mon Jan 23 19:48:27 EST 2012 | gaz
This make me curious how many people are using sn100 versus how many using sac305. The sn100 seemed to generally cover the pads and flow a little better, and looked nicer, but SAC305 overall was easier. Is this normal or do I need to work more on sa
Electronics Forum | Thu Feb 15 10:48:34 EST 2007 | ck_the_flip
Is there anybody out there doing this scenario: SAC 305 Reflow & SN100C Wave and Selective Can the 2 alloys be mixed on 1 board, say, SAC 305 for SMT, and SN100C for thru-hole? Are 2 different rework chemistries needed, or can one use SN100c wire
Electronics Forum | Fri Apr 09 09:08:40 EDT 2010 | cast2010
Hello, I produce two types of board. - 100% Thru Hole - 50% thru hole and 50% SMT For the second, I have a bad wetting after the reflow on the top. The pcb board have Au-Ni pad. I use a water soluble paste. I clean the board with a solution with
Electronics Forum | Thu Feb 15 14:10:59 EST 2007 | Cmiller
Russ is correct. We have been using SAC 305 for SMT and SN100C for wave and selective and repair for about a year. May switch to SN100C in SMT at some point if we can get some paste that wets better.
Electronics Forum | Tue Feb 20 16:42:31 EST 2007 | ratsalad
We have been using SAC 305 for reflow and Cobalt 995 (very similar to SN100C, only cheaper) for wave and rework for quite a while now with no issues that I'm aware of.
Electronics Forum | Wed Sep 04 07:15:02 EDT 2013 | anilw2006
We have using SAC305 type solder paste for lead free process. One sample paste received of SN100C.After reflow SN100C type paste joint looks brighter and good compare to SAC305. Please help me which paste is good for smt process?
Electronics Forum | Fri Nov 09 16:31:02 EST 2007 | dmunson
We are using SAC305 for reflow and SN100C for our selective solder.
