Electronics Forum | Mon Oct 05 10:08:54 EDT 2015 | swiese242
I have a HVC 102 reflow oven that will randomly shut down for over/under heat. On the 601 overheat protection zone 4 will read over 500c. Has anyone had this problem?
Electronics Forum | Wed Sep 12 00:42:35 EDT 2007 | duyhoang
Hi all, I've just bought a second-hand oven HVC102. Unfortunately, The Computer broke and software disabled. anyone helps me to have a new sofrware? Thanks very much,
Electronics Forum | Wed Sep 12 12:55:38 EDT 2007 | chrisgriffin
I can help you. Send me an e-mail. Do you know what version you had? chris.griffin@smtsupport.com
Electronics Forum | Tue Mar 01 23:55:41 EST 2011 | cmguan79
Hi all, Need help troubleshooting for I've just bought a 1997 second-hand oven HVC102. Unfortunately, after loading profile & press run mode we found all TC READING IS ZERO & CONVEYOR READING FEEDBACK IS ZERO SHOWN ON MONITOR SCREEN ,& I LOSS PA
Electronics Forum | Fri Jun 29 18:36:54 EDT 2018 | crstarr
Hello - I just purchased a used Conceptronic (Philips) HVC-70 Reflow Oven and am in need of the complete manuals (wiring; programming; maintenance; etc. -OR- Someone who currently uses this oven and/or knows everything about it. I was told this o
Electronics Forum | Thu May 30 20:09:58 EDT 2002 | myu
Thank you very much, Dave and Steve. I got paste and wire from Indium and Qualitek. Are there anybody with high-temperature reflow experience (330 degree C)? Is it OK to use Regular Convection Reflow Oven (We have a Conceptronic HVC 70, 5 zones) ?
Electronics Forum | Thu Jan 08 16:21:05 EST 2004 | Bill
James: The ovens can be calibrated to help get this a little closer. In the computer box are 3 cards (alike) attached to the motherboard. They are called IPS-7 cards. On these cards are 2 potentiometers to calibrate the T/Cs for the heat zones. There
Electronics Forum | Wed Jan 07 13:17:56 EST 2004 | James
We currently have 2 HVA 102 conceptronic reflow ovens. I ran 2 profiles on the 2 seperate machines. One of the oven ran 7 degrees lower than the other oven. I checked all the fans and they seem to running fine. I get no warning on the monitors.
Electronics Forum | Thu Mar 10 12:46:17 EST 2005 | jimk
Does anyone have experience in N2 supply source for reflow oven (1000scfh) other than N2 generator? Tanks, liquid, etc. We are in the developement stages of lead free processing and would like a quick, short term solution for providing N2 to a Concep
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
