Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Thu Aug 30 20:58:50 EDT 2007 | ronsou
Hello all Has anyone ever upgraded their machine from the Hydra camera to the linescan camera? I was wondering what your cost was. I recently requested a quote and almost fell out of my chair when I recieved it. Thank Ron
Electronics Forum | Tue Sep 29 13:59:08 EDT 2009 | cyber_wolf
The Hydra camera is a linescan camera on our machine.
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Thu Sep 01 17:20:06 EDT 2005 | Mike
Is anyone currently mounting 0201's with the Hydra/Linescan combination with good results? We have a My series machine and are currently mounting the 0201's with high res camera. The results are good but it is painfully slow. Thanks in advance for
Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Mon Aug 21 14:27:47 EDT 2006 | Gary
Watch out for the tube and camera. Tubes are over $20K and cameras can go over $15K. There are no reputable service suppliers for these. If you want a good refurbished machine with warranty call Rework,Inc. 760-458-0733. Gary
Electronics Forum | Tue Sep 24 08:33:39 EDT 2013 | joekirin
The mechanical centering is used for testing resistors, caps, and other various components. It is also used to center parts by "tapping" them with a set of jaws. When the head picks up the component, it is between these jaws. Each part is setup to
Electronics Forum | Wed Apr 26 14:06:46 EDT 2006 | mdm4ua
Hi JEM, We just made the very same upgrade you are looking to make on three machines. We purchased a new MY12 and upgraded our other three (My9 W/hydra, My9 No Hydra, and TP9-2U) from 2.2.4C to 2.4.4c. There are several changes and most of the
.gif)
winsouce.jpg)