63 reg results

Electronics Forum: reg (Page 1 of 7)

career change

Electronics Forum | Fri Dec 08 21:36:42 EST 2000 | reg

Hi everyone!! I have less than one year in the US, and I had been working as a field smt engineer. I have almost two years of experience as a manufacturing engineer, but what I really would like to do is process engineering. Can somebody advice

Selective pallet thickness

Electronics Forum | Tue Apr 10 02:41:18 EDT 2001 | reg

So I basically want it as thin as possible then? Sounds good to me. Ta

Part Desc from Fujicam

Electronics Forum | Tue Oct 16 12:50:21 EDT 2001 | reg

Can anyone tell me how I can get Fujicam to add the component value/desc onto the set up sheet automatically instead of the defalt "variable" under the Status column. Thanks

Mats for large mech assy

Electronics Forum | Sat Sep 21 11:53:01 EDT 2002 | reg

Hi. Can anyone point me in the direction of a company (preferably in the UK. Scotland would be even better) I could buy mats from. I'm looking for 700mm square mats for transporting a mech assy between stages down a roller converyor. I've used ones b

Snapshot Process

Electronics Forum | Fri Jan 31 05:18:10 EST 2003 | reg

We have a customer who is going to be using the new Snapshot process. Has anyone used this process all ready. Who did you use to make the tooling etc. Was there any problems that arose during this process. The process involves screening balls into s

PCB packing / shipping standards?

Electronics Forum | Fri Aug 06 11:25:09 EDT 2004 | reg

Hello. I'm trying to find out if there are any standards with regards to how a PCB is packaged and shipped. I'm particulary looking for info in whether or not ESD bags are required for an assembly in a metal enclosure. Thanks.

campos

Electronics Forum | Mon Apr 03 13:51:31 EDT 2006 | reg

When using lead free bgas and tin lead paste is almost certain that you will find voiding no matter what type of profile is use. The best thing that you can do is optimize your profile to minimize the voiding.

Stencil Cleaners

Electronics Forum | Mon Apr 03 13:44:46 EDT 2006 | reg

I am looking for recommendations about stencil cleaners and board washers. We currently use WS, No clean and Lead Free paste.

Tooling for printers

Electronics Forum | Wed May 10 12:22:45 EDT 2006 | reg

Hi everyone, I am trying to evaluate the cost of buying new equipment. One of the concerns is blade holders, stencil frames and board vacuum tooling. How difficult is to change from Dek to MPM or viceversa without changing all our tooling.