Electronics Forum | Tue Nov 27 19:42:58 EST 2001 | mparker
Dave - will placing MELF's in SMT eliminate the original problem? Is the flux aggressive enough to clean mold release agents from the component manufacturer? Good point about LT reliability, just wondering what would happen if glue was eliminated fr
Electronics Forum | Thu May 20 08:51:29 EDT 2010 | jry74
A lot of our dewetting is happening on plastic body components, such as ICs. When they are manufactured, the molding process requires a mold release to make the part release after molding. Usually, the release agent is silicon based, but you can't
Electronics Forum | Tue May 25 11:37:50 EDT 2010 | davef
Where on the assembly is the dewetting occurring? Factors that influence dewetting usually involve non-ionic contamination such as: * Residues from board manufacture including silicone surfactants from solder resist & HASL rinse contamination * Comp
Electronics Forum | Fri Dec 10 12:24:46 EST 2010 | davef
Causes of dewetting in conformal coating. Factors that influence dewetting usually involve non-ionic contamination such as: * Residues from board manufacture including silicone surfactants from solder resist & HASL rinse contamination * Component res
Electronics Forum | Fri Jan 05 09:23:10 EST 2001 | Brian Toleno
While there may not be any specific requirement to cleaning prior to coating, cleaning an assembly prior to coating will only serve to increase the reliability and integrity of the coating. Some residues from low-solids fluxes can interact with conf
Electronics Forum | Wed Jun 03 01:06:13 EDT 1998 | Mike Moninger
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Tue Jan 30 20:38:32 EST 2007 | davef
NASA Internal Advisory: NASA-Issued Return to Flight Wristbands Contaminated with Silicone [snip] 10. PROBLEM DESCRIPTION: Recently we have been made aware of a silicone problem associated with the "Return to Flight" wristbands. These wristbands are
Electronics Forum | Tue Feb 03 13:39:08 EST 2009 | grics
Good morning Jamie. I work at a CM and can offer some input on process flexability. I do not have any data on how reliable the coating is but I can say that they are both very difficult to control. Will you be selective coating or full coating? Ho
Electronics Forum | Wed Jul 05 22:29:06 EDT 2000 | George
Matt, I suppose the automated system you refer to is the VPD-101 camera system that captures component image and with a few clicks on the mouse you are able to define all the element data and dimensions of that part. Check with your local Fuji agent,
Electronics Forum | Mon Jun 07 08:46:53 EDT 1999 | Jason Gregory
|Yes, I am aware of this machine being a Sanyo. I was told, however, that due to confidential agreements, Sanyo will not release any information pertaining to the specs of the machine. I was hoping to obtain the specs of the cutting blade to make my
winsouce.jpg)