Electronics Forum | Tue Nov 13 19:52:47 EST 2001 | davef
1800??? That's not a Mictor part number. Huh? What??? Haaaa!!!! You gotta do what???? 1800 ofem??? Haaaa!!!! Sorry. It�s simple. Just ... * Cut all the SMT gull wing leads on both sides of the connector just above the solder. * Put the co
Electronics Forum | Thu Jul 30 03:34:52 EDT 2009 | babe7362000
The parts are from 2000-2004. The temperature at the leads are between 215-220. When the part is removed from the board, some of the leads are nice and shiny and some have dewetting, so I dont think it is a temperature issue.
Electronics Forum | Wed Jul 29 12:48:25 EDT 2009 | mikesewell
Kester R562 is listed as an ORH0, a high activity flux, not sure switching pastes would gain much. What is the finish on the leads? How old are the parts? You could have the parts reconditioned (SixSigma, Corfin, ...others) but this can get costly
Electronics Forum | Wed Jul 29 10:46:04 EDT 2009 | babe7362000
I was wondering if anyone knows the best way to clean oxides off of fine pitch components? Apparently the paste we use does not have strong enough flux to remove the oxides off of the leads of the components. I have validated the profile and that i
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
Electronics Forum | Wed Jun 16 15:07:00 EDT 2004 | jsmith01
I ran some test samples with a water soluble past (Amatech ws488). I also tried hand soldering using an Alpha ws375 wave soldering flux and some old fashioned RMA. The results are pretty much the same. Some of the joints look a better that others b
Electronics Forum | Tue Jun 24 17:41:29 EDT 2003 | MikeF
I'm looking for an esd safe tray, something like what pharmacists use, that we can use to count out loose parts. Has anyone seen something like that? We have a lot of part values in our stock room that have maybe 100 or so loose parts in a bag. The
Electronics Forum | Thu Mar 08 09:08:47 EST 2001 | jax
Your safest bet is to manually remove the trays. The problem with what you want is that the machine does not know that it missed a part. It simply goes to the point you specify and tries to pick somthing up; if it doesn't pick up anything it believes
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Fri Jan 08 08:29:48 EST 2016 | ahanna
Water can be the issue. After Christmas break we came back to find a fair amount of water build up in our airlines for the building. I will check out the regulator as well as the solenoid. Thank you. I appreciate it.
.png)
