Electronics Forum | Thu Jul 30 03:34:52 EDT 2009 | babe7362000
The parts are from 2000-2004. The temperature at the leads are between 215-220. When the part is removed from the board, some of the leads are nice and shiny and some have dewetting, so I dont think it is a temperature issue.
Electronics Forum | Wed Jul 29 12:48:25 EDT 2009 | mikesewell
Kester R562 is listed as an ORH0, a high activity flux, not sure switching pastes would gain much. What is the finish on the leads? How old are the parts? You could have the parts reconditioned (SixSigma, Corfin, ...others) but this can get costly
Electronics Forum | Wed Jul 29 10:46:04 EDT 2009 | babe7362000
I was wondering if anyone knows the best way to clean oxides off of fine pitch components? Apparently the paste we use does not have strong enough flux to remove the oxides off of the leads of the components. I have validated the profile and that i
Electronics Forum | Tue Oct 09 12:04:37 EDT 2001 | Mike
Has anyone looked at setup reduction for machine feeders. We have made some gains through changing the flow of work but as lot sizes decrease the number of parts required remains the same. We remove all reels from the feeders after a job is complet
Electronics Forum | Tue Oct 09 16:25:26 EDT 2001 | meowen
Unfortunately 95% of our runs require both sides of our Universal HSP's. We also have carts that hold one carriage worth of feeders on each side. Parts that carry over from one product to the next are flagged and relocated in the machine per the ne
Electronics Forum | Tue Nov 13 19:52:47 EST 2001 | davef
1800??? That's not a Mictor part number. Huh? What??? Haaaa!!!! You gotta do what???? 1800 ofem??? Haaaa!!!! Sorry. It�s simple. Just ... * Cut all the SMT gull wing leads on both sides of the connector just above the solder. * Put the co
Electronics Forum | Thu Oct 16 05:31:46 EDT 2008 | khushi
How to remove scratches from the metal surface of feeders in Pick & Place machine
Electronics Forum | Thu Feb 02 21:14:16 EST 2006 | ____
Fuji America has feeder maintenance manuals for all of the machines. Some of them are on CD-ROM with a step by step procedure. For parts however, you need to be registered (Fuji Japan) so that you can enter the serial number and find the exact part n
Electronics Forum | Tue Jun 25 11:26:11 EDT 2002 | pdt203
Sometimes when a customer has sent parts on reel without any leader, we will take out the first 5-8 parts and then tie off the cover tape with some leftover tape from the last run. We keep those parts we removed and then place them back in the feede
Electronics Forum | Tue Jan 09 06:45:08 EST 2018 | micomac
We have Europlacer flexys pick and place. We have had 3 turret collisions with 8mm feeders arising from the tape retaining clip coming free during operation. Have asked Europlacer for part numbers for safety catches that a technician told me existe
winsouce.jpg)
