Electronics Forum | Tue Nov 13 19:52:47 EST 2001 | davef
1800??? That's not a Mictor part number. Huh? What??? Haaaa!!!! You gotta do what???? 1800 ofem??? Haaaa!!!! Sorry. It�s simple. Just ... * Cut all the SMT gull wing leads on both sides of the connector just above the solder. * Put the co
Electronics Forum | Thu Jul 30 03:34:52 EDT 2009 | babe7362000
The parts are from 2000-2004. The temperature at the leads are between 215-220. When the part is removed from the board, some of the leads are nice and shiny and some have dewetting, so I dont think it is a temperature issue.
Electronics Forum | Wed Jul 29 12:48:25 EDT 2009 | mikesewell
Kester R562 is listed as an ORH0, a high activity flux, not sure switching pastes would gain much. What is the finish on the leads? How old are the parts? You could have the parts reconditioned (SixSigma, Corfin, ...others) but this can get costly
Electronics Forum | Wed Jul 29 10:46:04 EDT 2009 | babe7362000
I was wondering if anyone knows the best way to clean oxides off of fine pitch components? Apparently the paste we use does not have strong enough flux to remove the oxides off of the leads of the components. I have validated the profile and that i
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
Electronics Forum | Mon Oct 10 08:02:01 EDT 2022 | furman
Dear Friends, we scrapped our Siemens Siplace 80 S15 FS02 and removed all mechnical parts, heads, Servomotor and steering PCBs. Additionally, we have brand new 2x8mm fast feeders NEW (unpacked but never used). If anything is needed please contact
Electronics Forum | Thu Sep 19 15:39:16 EDT 2019 | qanalyst1
When baking parts at 90C that require 15 hours bake time with parts that require 25 hours bake time, is it acceptable to open the oven and remove the former (15 hours) parts and then continue the 25 hours cycle for the remainder of the parts in the o
Electronics Forum | Thu Jun 28 09:38:14 EDT 2012 | 14367
PSMN130-200D MOSFET TRANSISTOR D2PAK - failure of some parts led to investigation, oxidization or surface contamination was noticed on remaining parts. The surface contamination could be removed when fingernail was drawn over the bottom terminating s
Electronics Forum | Thu Jun 28 09:38:20 EDT 2012 | 14367
PSMN130-200D MOSFET TRANSISTOR D2PAK - failure of some parts led to investigation, oxidization or surface contamination was noticed on remaining parts. The surface contamination could be removed when fingernail was drawn over the bottom terminating s
Electronics Forum | Thu Mar 08 09:08:47 EST 2001 | jax
Your safest bet is to manually remove the trays. The problem with what you want is that the machine does not know that it missed a part. It simply goes to the point you specify and tries to pick somthing up; if it doesn't pick up anything it believes
