Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Tue Feb 07 16:32:13 EST 2023 | glasscake
Good ventilation is also important to removing aerosols and other vapors. Make sure your building HVAC is pulling in a good portion of outside air. If people are complaining try to up the ratio of recirculated/outside air. This will add cost dependin
Electronics Forum | Sun Jul 05 22:21:58 EDT 2020 | raoult
Hi, The micro switch is broken on my device, it was a tactile one (4mm) : image1, image2 Do you think I can buy another one and just solder it like this with 2 wires (I can't solder it back to where it was because it's too tiny I don't have the sk
Electronics Forum | Mon Jul 06 21:16:59 EDT 2020 | raoult
Thanks guys for your help. Sorry for the pic quality, the device is so small I had to zoom a lot with my phone. The switch is a tactile one, the plastic body is missing, and what you can see in the center is where the contact is made : when the swit
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)
