Electronics Forum | Tue Jun 20 10:46:08 EDT 2023 | dontfeedphils
Usually best to stick with older/tested OS for machines/software compatibility. Or setup a VM with Win7 or Win10 in your main machine to handle picky software suites.
Electronics Forum | Mon Dec 17 09:59:50 EST 2018 | crstarr
Hello - We have two Quad QSA-30As that won't boot. These two machines haven't been run since October (they are backup machines), and there were some heavy lightning storms that month. We think both mother boards may have been zapped. We replaced
Electronics Forum | Mon Feb 18 09:46:42 EST 2019 | cdav1100
We currently run a Yes Tech BX machine using the Yes Vision software on Windows 7. With Windows 7 support running out in January next year, I was curious if anyone had managed to run the Yes Vision software under Windows 10. The obvious answer is to
Electronics Forum | Tue Feb 17 09:33:43 EST 2015 | emeto
Hello, I have two of these for the last 3 years(MV-7xi). Buy the machine with the best camera they offer and with the telecentric lens - it gives great view and resolution. I had to replace the controller for conveyer open/close on both of them. I a
Electronics Forum | Fri Dec 15 08:32:13 EST 2017 | robertorocco
Hi Pavel it is possible to clone the hard disk topaz machine to replace it in the future crashed? how should I do to save the calibration data of the machine?
Electronics Forum | Mon Aug 25 01:19:51 EDT 2008 | chrispy1963
We've got an older Conceptronics HVA102, 7 Zone, relow oven running software with the following info: (1) Machine Software Ver. Date: 9-1-94-Windows Rev 2.50c. (2) EPROM rev for the machine is: 386 AT WINDOWS (3) 486DX2 PC running Windows 3.1 as
Electronics Forum | Sun Mar 17 06:16:44 EDT 2013 | christian01976
Hello! You need an upgrade on AMS3.0 to use it with Windows 7. And then you need a dongle for every PC you want to use it on. And with that step ypu dont need a floppy anymore you can register the machines with usb stick or over network. Christian
Electronics Forum | Fri Mar 13 10:24:35 EDT 2015 | assuredtech
I am setting Fuji Flexa to communicate with CP8 > machine. When I create a new machine, I has to > fill out the following value Machine > Communication Server: ? Get Production Data : > (yes/no) GEM Host Name: ? Disable GEM : > (Yes/no) TCP/IP
Electronics Forum | Tue Jul 15 16:26:14 EDT 2008 | lharris
Our company has a Novastar benchtop wave solder machine, WSL-P series, model 7PD. We need to replace the pulley drive motor/pump, as some of the teeth on one of the gears are worn down/gone. Any idea where I can procure a replacement? Please provide
Electronics Forum | Wed Jun 19 11:34:37 EDT 2013 | chifutbol
"The disk of B drive has not been formatted as a PCB Data disk." This is the error I'm getting when trying to install lines on a new installation of the Gemline PCB Editor. I have tried using a new floppy, formatted in both opal and topaz machines,
winsouce.jpg)