90 replacement belt results

Electronics Forum: replacement belt (Page 1 of 9)

CP40LV Timing belt replacement

Electronics Forum | Tue May 10 20:38:04 EDT 2011 | wolverine

I am going to have to install new timing belts in a Samsung CP40 series machine, these are the belts that run on each side of the placement head gantry. Do not have technical support from Samsung nor do I have a service manual for the machine, just t

GSM Flex head theta belt replacement

Electronics Forum | Mon May 11 17:03:05 EDT 2015 | dilogic

Any advice how to (easily) replace theta timing belt on GSM Flex head?

Panasert mv2f floppy drive replacement

Electronics Forum | Fri Oct 23 05:02:34 EDT 2020 | gabriel1blue

I change the settings to match another machine we have and that actually got the original drives working after replacing the belt. I ordered an adapter that will connect to the 26 pin flat cable and adapt to a 34 pin connector and pull the power from

SMT/ PCT edge conveyor replacement belts

Electronics Forum | Fri Dec 07 13:38:06 EST 2007 | ehess

Does anyone kbnow where I can find replacement belts for the old PCT (Process control Technologies) conveyors?

replacement converyor belts for PCT edge conveyors....

Electronics Forum | Mon Feb 19 15:18:29 EST 2007 | EHess

Anyone know of a good source for replacement belts for PCT edge conveyors of various sizes? Thanks

Panasert mv2f floppy drive replacement

Electronics Forum | Thu Oct 22 22:13:20 EDT 2020 | gabriel1blue

I got new belts for the original floppy drives and installed them but the machine was reset to Japanese and after changing it back to English the drives are not running or powering up even though we can measure that the 5 volts are coming into it. I

SMT/ PCT edge conveyor replacement belts

Electronics Forum | Thu Dec 13 09:55:18 EST 2007 | cyber_wolf

How do you melt it together ?

inline smt 1m 2 stage conveyor belt

Electronics Forum | Fri Feb 11 20:16:43 EST 2022 | mihai_voivod

Hi guys, This stubborn conveyor (inline smt 1m 2 stage) keeps popping off its track. I have tried to replace the old belt, turn the new belt around, tighten it as much as I can, but it keeps coming off the little wheels as shown in the picture. D

SMT/ PCT edge conveyor replacement belts

Electronics Forum | Fri Dec 07 14:44:35 EST 2007 | actech

I have ordered 3/16th and 1/4 from McMaster Carr in the past. you buy it bulk cut it at an angle and melt it together. I think its Mcmastercarr.com and look into belts or conveyor belting you should be able to find it online there.