Electronics Forum | Thu Nov 16 12:52:04 EST 2017 | charliedci
We installed a SonoFlux ultrasonic spray fluxer, replacing the foam fluxer in our Electrovert Econopak wave in 2014. The cost at that time was 16K, installation included. We ran water based flux through it and as long as we kept it clean, worked well
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Feb 16 16:52:51 EST 2015 | joe98375
Hello, We are buying a Vitronics-Soltec wave solder machine with a spray fluxer to replace our old Econopak that has a foam fluxer. Currently we thin our flux (Kester 951) in the foam fluxer per Kester PS-20 and PS-22 test kits with kester 110 thinn
Electronics Forum | Fri Dec 08 23:02:24 EST 2000 | LeeKibler
Beware the foam fluxer. I had a problem with cracked caps that just about drove me off the deep end. I discovered that my foam fluxer air knife was not turned on resulting in excessive flux. The excessive flux (VOC free) was not properly dried off
Electronics Forum | Tue Aug 17 11:31:39 EDT 2004 | Cal
Hello All- I need to replace my Foam flux aerator in my wave soldering machine and need a source. The "Stone" Size is 38x25mm @ 3um. If any one has a source thanks in advance. OBTW- this wave not a "Name Brand" machine (i.e. Eltrovert). Cal
Electronics Forum | Wed Oct 25 11:33:44 EDT 2006 | bill
I have inherited a SonoFlux 9500 spray fluxer. It appears to have never been used and was build in 1999. It is missing the nozzle and a couple of other parts. Would it be worth it to get this thing up and running to replace a foam fluxer? Does an
Electronics Forum | Wed Jan 26 17:02:22 EST 2000 | Morris
One thing I've found that will create that white residue is when moisture comes in contact with that flux. 1. Verify that you are not introducing any moisture with the compressed air supply at the foam fluxer. 2. Replace the flux and clean the flu
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Wed Nov 04 02:53:53 EST 1998 | Earl Moon
| Micheal, | | What does your profile look like for the wave? What profile does your flux say you need? My guess is it is not your profile, our testing with solder balls found that the mask on the boards was the largest contributor to solder balls
| 1 |
winsouce.jpg)
