Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho
Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you
Electronics Forum | Tue Feb 10 12:16:40 EST 2004 | zaxx007
Dear Kratzman, We had one of their waves an 8FD and we had the worst time getting replacement pre-heaters, I would stay away, just my oppinion. Zack
Electronics Forum | Wed Mar 13 06:37:24 EDT 2013 | jlawson
Not knowing XPM ovens , have zones are usually top heat and bottom, you replaced one heater panel-platten thus have a another above or below, maybe one above or below also is faulty causing heat spot on one side of oven ?
Electronics Forum | Thu Nov 08 14:36:04 EST 2007 | dphilbrick
I have had an Advantek machine for 10 years, replaced 1 heater and that's it. We don't tape every day but we use it quite a bit. Wouldn't do anything really small with it but SO's on up- no sweat. Pretty easy to change over too, stockroom girl does e
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Fri Jun 15 13:43:48 EDT 2007 | realchunks
I do want to run a profile, but they won't give > up the machine long enough for me to run one. > The boards that we are running through the wave > are large boards, with large caps, and large > transformers on it. We're building highend power
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Tue Oct 26 22:24:21 EDT 2004 | KEN
More zones = higher thruput. Is it better to have (8) 12 inch zones vs. (7) 15 inch zones? One thought might be more parts = more cost = more potential for failure. I have a bunch of BTU's with over 12,000 heating hours of combined opertion. I
Electronics Forum | Wed Sep 16 18:06:14 EDT 2015 | pmcg
Problem with cleaning these machines is once you start it's easy to get carried away. ;) We cleaned our SPA-400F a few months ago, had been offline for a while as we were using our SPA-250. It started as just a clean and to replace all the flux pip
Electronics Forum | Mon Oct 12 03:09:06 EDT 2015 | akon63
Problem with cleaning these machines is once you > start it's easy to get carried away. ;) > > We > cleaned our SPA-400F a few months ago, had been > offline for a while as we were using our > SPA-250. > > It started as just a clean and to > r
