Electronics Forum | Tue Nov 22 09:52:57 EST 2005 | moonshine
Might be resin smear. Check out all the stuff on my free site as articles, photos of almost every board defect imagineable plus much more. Did I mention, It's ALL FREE ALL THE TIME? MoonMan
Electronics Forum | Wed Oct 19 07:44:33 EDT 2005 | davef
When a hole is drilled during board fabrication, it can transfer resin from the base material (eg, FR4 core or prepreg) to cover the exposed edge of conductive material in the wall of a drilled hole. This is called resin smear. Etchback is a control
Electronics Forum | Thu Jul 15 12:26:56 EDT 1999 | Earl Moon
| We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwe
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Wed Jun 10 18:40:00 EDT 1998 | Earl Moon
| I am looking for the Industry standards on vias. Are they required to be plated with solder or is copper plating enough? What about reliabilty with either one? Also, if tenting the via is required should it be copper plated or solder plated over
Electronics Forum | Fri Feb 14 12:22:57 EST 2020 | etmpalletguy
OK, you can't glue, Pallet Guys pallets are out the door, dual line reflow prevents from any lower temp solder paste.... Do you have a 3D printer? Are there parts underneath the connector in question? Measure the PCB thickness, pint out a custom hold
Electronics Forum | Thu Jul 15 19:05:58 EDT 1999 | Earl Moon
| | | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec
Electronics Forum | Wed Feb 25 09:22:53 EST 1998 | Earl Moon
PCB Fabrication Supplier Evaluation And Qualification Made Easier Supplier evaluation and qualification often is left to uninformed industry references or vague suggestions made by sales unprofessionals. This discussion is met to enhance a customer'
Electronics Forum | Wed Feb 25 09:21:05 EST 1998 | Earl Moon
PCB Fabrication Supplier Evaluation And Qualification Made Easier Supplier evaluation and qualification often is left to uninformed industry references or vague suggestions made by sales unprofessionals. This discussion is met to enhance a customer'
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
