Electronics Forum | Tue Oct 26 15:44:35 EDT 2004 | Paul_pmd
Hi Mike, Surface mount components arn't difficult to work with at all. They have pretty much the same tolorance to heat degridation as Dip packages. I suggest two Irons when working with two pole resistors and caps. Heating only one end at a time wil
Electronics Forum | Tue Apr 05 20:45:36 EDT 2022 | stephendo
Try adipic acid to clean your nozzles. It is a powder and can be awkward to work with as a result. But you might end up preferring it. Also look where the substance is not. There are two PTH joints without it. And that chip cap is closer to the PT
Electronics Forum | Tue Mar 01 05:26:14 EST 2005 | Rob
Hi Daniel, Yes there is such equipment available, I have seen it on the end of both Capacitor & Resistor production lines, but from what I can remember it was custom made. The cap line was testing 0402's. Hope that helps, Rob.
Electronics Forum | Wed Aug 23 17:06:40 EDT 2000 | Dr. Ning-Cheng Lee
For 20 mil pitch pads, the volume control is more critical in terms of bridging concern. In general, solder paste for dispensing is more prone to slumping due to low metal load and low viscosity. If the volume dispensed is on the high end, or if the
Electronics Forum | Fri Feb 11 03:51:04 EST 2005 | Rob
Positive side: Less change overs, increased productivity 1/2 booking in & replenishement functions Negative: If you have more than one SMT line,common part numbers & a MRP system it may tell you you can run 3 jobs at once with 1 reel Some machin
Electronics Forum | Wed Jul 06 04:27:30 EDT 2005 | aj
Javi, If the components are caps and resistors etc there should not be much problems. I would say everyone at this stage has a mixture of leadfree and lead components. The problem really starts when you are running the likes of Leadfree BGA where th
Electronics Forum | Thu Feb 10 09:13:10 EST 2005 | russ
cap and resistor Parts are cheap! $10 vs. $20 or so? If you are worried about inventory cost than only buy your top 10 or so runners in the large reels. I am a big fan of large reels for the high running caps and Resistors.
Electronics Forum | Thu Aug 28 02:51:01 EDT 2014 | padawanlinuxero
When you say "selecting correct value of the small chip components during assembly", you are referring to caps and resistors? and that you want to know that the correct cap or resistor was place in the correct location? your assembly is surface moun
Electronics Forum | Fri Sep 15 04:09:15 EDT 2017 | philc
Yageo announced their decision to stop marking SMD resistors back in 2013, and since then we have started to see 0603's that aren't marked, but larger sizes - so far - are still showing a value. 0402's have never been marked, and I doubt they ever w
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two