Electronics Forum | Mon Jun 14 11:39:29 EDT 1999 | Marshall
| | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from m
Electronics Forum | Thu Jun 17 10:37:42 EDT 1999 | Brian Wycoff
| | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from
Electronics Forum | Thu Jun 17 11:18:03 EDT 1999 | Ian Clelland
| | | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down fr
Electronics Forum | Fri Apr 30 18:28:57 EDT 1999 | Mike Doherty, EMCO High Voltage Corp
We are searching for an integrated passive component (or device) consisting of a resistor in series with a capacitor in an 0805 package. Cap value is .01uF, resistor value up to 1 meg. Any suggested sources appreciated. Miked@emcohighvoltage.co
Electronics Forum | Wed Jun 16 15:44:52 EDT 1999 | Jagman
| WOULD LIKE TO DO RELOW OF 2 SIDED SMT BOARDS. USUALLY THE BOTTOM SIDE HAS RESISTORS AND CAPS ONLY. WHEN THE BOTTOM OF THE BOARD HEATS UP, THE PARTS ARE FREE TO MOVE AND ONLY SURFACE TENSION WILL KEEP THE COMPONENT FROM FALLING OFF. | CAN BOARDS BE
Electronics Forum | Tue Feb 23 16:55:43 EST 1999 | Joe Zuchowski
| who do you like to go to as a source of | caps, resistors, ICs, DIPs, connectors | | I'm looking for distributors. | | For I.C.'s I have had good luck with Future/FAI, Arrow, Western Resources, and Vista Mfg. Co. in K.C., Classic, Insight Cap
Electronics Forum | Wed Jul 17 10:22:36 EDT 2013 | ericrr
argh! the 6 ends of the resistors soldered to another though hole part to give the pcb track mechanical strength or are they just soldered to a remote pad, so if the resistors are knocked it has the possibly of ripping the track from the pcb.
Electronics Forum | Tue Jun 23 08:39:22 EDT 1998 | Jon Medernach
What is the level of interest in bulk feeding cpassive devices, caps & resistors, 0402,0603,0805? The component mfgs. tell me in 3 years 40% of the passive caps will be bulk fed. Their is currently about a 10% cost savings with bulk over tape & ree
Electronics Forum | Thu Oct 11 06:36:57 EDT 2007 | cyber_wolf
Feeder is brand new. (Checked cal. even though it was new) Lighting is good. Machine is in perfect cal. Nozzles are brand spankin new from Fuji. I was able to lower the reject rate considerably by playing with the offset and gain. I am placing caps
Electronics Forum | Tue Jun 27 10:51:42 EDT 2000 | Ioan
Hi Bill, there are a couple of things you should check. Most likely you have too much paste which is squashed at the insertion of the cap. - the paste height, around 7 mils should do. Too much paste will cause shorts under the cap at insertion which
