Electronics Forum | Thu Aug 27 00:08:51 EDT 2020 | smith88
In IPC 9.2 it shows missing paint the pic is terrible, is the missing paint the defect or is it damaged down under a protective layer that is the internal element.
Electronics Forum | Thu Aug 27 13:30:04 EDT 2020 | emeto
If there is damage of the glass coating or exposure of the resistive element it is a defect.
Electronics Forum | Wed Mar 30 14:02:25 EDT 2016 | blnorman
The program I'm working on is having endcap metallization/resistive element failures. These are on MELFs manufactured by IRC/TTE (MCHP). A sister program is having the same issues. They pulled a couple of date codes and did visual examination and
Electronics Forum | Fri Sep 08 11:50:39 EDT 2006 | Rob
SN100C is designed not to corrode your pot, and can be used on standard solderpots (after a proper clean out), whereas SACX is still corrosive and if the coating is compromised then could cause problems. Get it in writing from the supplier that the
Electronics Forum | Fri Sep 08 09:10:32 EDT 2006 | Claude_Couture
Hello all, The situation: We recently had 2 brand new solder wave installed, one after the other. On the first one, the "protective coating" on the solder pot started to flake off 1 day after start-up. The tech who did the installation witnessed it a
Electronics Forum | Thu Nov 29 08:16:47 EST 2001 | Hussman
Unless your wave is very, very, very old - you are having your leg pulled. Or someone in your maintenance dept. is a little out of it. Most pre-heaters are already coated to prevent rust. Maybe the coating has flaked away, if so, I'd suggest using
Electronics Forum | Fri Sep 08 11:38:42 EDT 2006 | GS
Last april,I have seen same behavior on a pot using SACX. Phenomena happened just few days after start up of a brand new solder wave. I know they have got the pot replaced but I do not know what about the new pot if had same problem. I know they mad
Electronics Forum | Wed Aug 13 12:58:32 EDT 2003 | babe
Lets try this again, Every shelf system should be grounded individually. Every six feet per EOS/ESD requirements. Do not daisy chain anything. Secondly, Depending on the depth of paint,style of pain that your shelving system has. A static charge woul
Electronics Forum | Tue Oct 13 22:22:14 EDT 1998 | mike
| All Y'll | | How do you clean components that must be added to an assembled board after water wash? | | BACKGROUND | | Our basic process goes like this: | | 1 Print paste with OA flux, place, reflow, wash | 2 Repeat 1 | 3 Insert PTH, OA flux
Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
