Electronics Forum | Tue Apr 11 20:31:54 EDT 2000 | Dave F
Russ: You�re correct. I should have explained our reasons for preferring concave over convex better. First, we use both also ... we just prefer concave because they: * Don�t bridge any where near as easily. * Self-center better. * Seem to have mor
Electronics Forum | Mon Apr 10 11:56:35 EDT 2000 | Robert Hutton-Squire
Suggestions please... I have to place a number of 1206 chip resistor arrays on the bottom side of my PCB for wave soldering. The device consists of 4 x 0603 resistors in a 1206 package. The device is available with either concave or convex terminati
Electronics Forum | Sun Sep 26 14:09:24 EDT 1999 | jgodfrey
| | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than sp
Electronics Forum | Wed Apr 12 16:05:08 EDT 2000 | Russ
Thanks, Dave appreciate the info. One of my trains of thought was leading to the convex because I thought that having the "bump" would allow for easier wave soldering? I did look at some data we had and did find you to be correct, the concave hav
Electronics Forum | Mon Mar 21 12:02:09 EST 2005 | Rob
Hi Colin, Are you using the 1206 package with 4 elements or one of the higher density smaller packages? With the first type you can get them in both Convex or Concave terminations, with most of the solderability problems associated with using the C
Electronics Forum | Tue Mar 22 08:13:39 EST 2005 | Rob
Hi Colin, If it's easy for you to swap to Convex try the Rohm MNR14 series, Bourns CAY series or Eurohm NC Series. Else try a 10% apperture reduction - however we usually had a 6 thou stencil when we did this. Cheers, Rob.
Electronics Forum | Tue Mar 28 04:41:06 EST 2006 | Rob
Hi Rob, They want you to think that their products are subtly different & that they are not interchangeable, although they are in nearly all cases (this is different for high frequency RF design). Also your layout guys aren't going to love you wi
Electronics Forum | Mon Sep 27 04:08:25 EDT 1999 | Earl Moon
| | | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than
Electronics Forum | Thu Jul 20 15:37:53 EDT 2000 | Tekguy2000
These parts are flat chip resistor arrays that have 4 end terminations on each side. It looks liek an IC but is typically in an 0805 and 1206 package type with convex terminations. .031" pitch from termination to termination and .011" spacing between
Electronics Forum | Fri May 29 20:15:15 EDT 1998 | Steve Gregory
Whoo-doggies Jason, you said a mouthfull!! (GRIN) Anyways, 'member what I said about me being a pack-rat? Guess what? I found some documentation that I've had for a while that does document the self-alignment forces that goes on when reflowing. I ha