Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
Electronics Forum | Mon Aug 02 12:28:16 EDT 2004 | jbabson1
The speed control for the extend and retract is in the Part Data under Process data under MTU. John
Electronics Forum | Tue Mar 18 09:11:14 EST 2003 | Rob C
With a standard valve and no-clean solder paste you may get a few good dots. But, repeatability will be terrible too many variable, air-pressure, board height (two post nozzle), valve time on/off, retract height, retract time, etc... A RMA paste wi
Electronics Forum | Sat Jul 22 19:19:36 EDT 2000 | Paul Lancaster
Congratulations on your new position, Mike. I formally retract my former statement. I was misinformed and apologize for any misinterpretation.
Electronics Forum | Mon Feb 19 07:31:43 EST 2007 | jax
Check the nozzle. If these are the only two parts on the board that use a specific nozzle, it's a good place to start. The nozzle is probably not releasing well and shifting the component when trying to retract after placement...
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Wed May 15 05:31:53 EDT 2013 | jlawson
Also make sure nozzle retraction is ok, if nozzle shafts stick at different heights can effect laser centering stability.
Electronics Forum | Wed Apr 27 20:32:22 EDT 2016 | sonavc
Hi, I have DEK 265GSX. Just got error message " BOARD STOP NOT RETRACTED" Any help would be greatly appreciated. Thanks
Electronics Forum | Thu Nov 30 06:20:22 EST 2017 | JPR
Can any body suggest what is the reason behind SRT machine stepper motor malfunctioning as we are using VJ electronics Summitt 750 model having Sanyo Denki stepper motor. Stepper Motor fails sometime during picking up component or during placement no
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
