Electronics Forum | Sun Sep 17 22:50:20 EDT 2000 | Sartor
I am looking for a solution for gold finger cleaning and repairing.Can anyone recommend good solution(s)?Also,can anyone recommend a good flux paste source(s)?Thanks.
Electronics Forum | Tue Jul 10 18:03:49 EDT 2001 | pzohbon
Does anyone have a recommendation for a cleaning solution used in an ultrasonic cleaner for cleaning RMA solder paste off stencils and adhesive off pcb boards. I am going to be evaluating Armakleen 2001, Zestron Vigon SC 200, and Aqueous Technologies
Electronics Forum | Thu Sep 21 09:20:13 EDT 2000 | Ron H
What is the phone number or web address of Circuit Repair Corp?
Electronics Forum | Thu Sep 21 12:41:35 EDT 2000 | jackofalltrades
Cicuit Repair Corporation 45 research Dr. Havenhill, MA 01832 Phone# 978-374-5000
Electronics Forum | Wed Sep 20 16:01:05 EDT 2000 | jackofalltrades
We get solutions from Circuit Repair Corp. PS-054 Solder Strip PS-044 Electroclean PS-034 Nickel PS-024 Gold
Electronics Forum | Tue Jul 24 08:09:24 EDT 2001 | tommiller
I�m using Zestron's Vigon sc 200 in our ultrasonic cleaner. It works great for cleaning our adhevises and pastes (RMA and no clean) from stencils and misprinted PCBs. We used to use a saponifier which did a terrible cleaning job and was a real pain t
Electronics Forum | Wed Jul 11 20:20:44 EDT 2001 | davef
Your selections are good, assuming you are talking about cleaning raw paste, rather than reflowed RMA. Maybe add Multicore Prozone, JNJ Aquasonic, and Kyzen Aquanox.
Electronics Forum | Wed Jul 11 18:42:35 EDT 2001 | Darby
As I mentioned in the previous string we are happy with Electrolube "SSS". The guy who built our ulrasonic cleaners recommended it and it works very well. You don't have to change tanks or machines for a switch from paste to adhesive. It doesn't leav
Electronics Forum | Tue Jul 24 12:48:45 EDT 2001 | kerryn
Can you tell me a little bit about the Zestron product. How many stencils do you clean and much Zestron do you use per month? What is the cost? Do you mix it with water? If so, what temperature? How do you get rid of the waste? Thanks. Kerry
Electronics Forum | Sun Jul 15 17:48:51 EDT 2001 | kerryn
You should check the archives, there has been much written on this subject in the past. Asking about the correct chemistry is wise. It never ceases to amaze me how many people think ultrasonics will work without the proper chemistry. Without the rig
