Electronics Forum | Wed Feb 18 12:32:59 EST 2004 | babe
A hot plate should do it. Since your throwing the board away a good hot plate could get you to just above reflow topside and you could remove them all at one time. To do this however the bottom side of the board would probably be damaged, but you don
Electronics Forum | Wed Oct 08 11:18:41 EDT 2014 | wavemasterlarry
If its like my wave, the t-couple might not be mounted over a whole where the hot air blow out./ mounting it on the hot plate makes it over heat alot.
Electronics Forum | Tue Feb 29 08:25:42 EST 2000 | Engineer
Have you ever used the IR system, or do you think that hot air is better?
Electronics Forum | Tue Feb 29 08:25:42 EST 2000 | Engineer
Have you ever used the IR system, or do you think that hot air is better?
Electronics Forum | Tue Apr 13 14:10:47 EDT 2004 | russ
Who would these people listen to? Doesn't sound like anybody.
Electronics Forum | Wed Mar 14 09:58:07 EST 2001 | dason_c
I am not sure that how big of your shield, I am using Metcal Soldering System and modify the Metcal Removal Tip to cut into half. I don't want to use hot air and it may damage the component inside.... Rgds. Dason
Electronics Forum | Thu Apr 12 07:46:20 EDT 2007 | realchunks
Hi aram, Hot air is best. IR takes longer and is affected by the color of the part. Best post solder process that affects solder the most is handling.
Electronics Forum | Wed Oct 01 04:43:36 EDT 2008 | omid_juve
we need a soldering nozzle for this package that can be placed by the rework machine on a pads of this qfp (to make the pads planar) and then send a hot air and after the solder joint melt stop the hot air and pull up the nozzle do we have such mach
Electronics Forum | Mon Feb 28 08:18:03 EST 2000 | Engineer
I'm currently researching new rework equipment, and was wondering if anyone had any recommendations. We currently have an older PACE hot air system that has had mixed results. It tends to overheat the board and IC. Is the IR any better, or has hot ai
Electronics Forum | Mon Feb 28 08:18:03 EST 2000 | Engineer
I'm currently researching new rework equipment, and was wondering if anyone had any recommendations. We currently have an older PACE hot air system that has had mixed results. It tends to overheat the board and IC. Is the IR any better, or has hot ai
.png)
