Electronics Forum | Wed Jan 24 16:37:58 EST 2007 | MelS.
Does anyone know of facilities that just perform rework? I am in need of reworking approximately 1,000 panels in the greater Philadelphia area. (two components - one press fit connector, one a samll cap) Any input/advice would be helpful.
Electronics Forum | Fri Aug 10 11:20:37 EDT 2018 | horchak
Since your question is general I will be general. The most important thing for press fit connectors is the design, and the proper tooling. Design considerations for the PCB are proper finished hole diameter, type of plating on PCB and connector or pi
Electronics Forum | Fri Apr 08 05:10:10 EDT 2005 | siverts
What is Your customers requirements? Is the PCBA mounted with front/back connectors? Will the PCBA be mounded in a rack and connected to opposite connectors on the other side? In this case, if the warpage is more than approx 1-1.5 % You will then n
Electronics Forum | Tue May 06 22:15:06 EDT 2008 | davef
We agree. We consider mounting holes and press fgit socket pads to be "critical contact areas." Consider taking steps to prevent the production of such solder splats on your gold to help elimate gold rework. We discussed this previously here on SMTn
Electronics Forum | Tue Feb 02 10:12:50 EST 1999 | Justin Medernach
| Does anyone have any reliability data /concern on pressfit rework/repair - is there any qualified /characterized equipment /tools present in the industry? | What kind of effect does it have on barrel plating quality (1.5mil avg.) after 1 time rewor
Electronics Forum | Mon Jan 10 18:22:43 EST 2011 | eadthem
What we use for boards the engineers made to big is aluminum flat bar 1/8 to 1/16 thick about 1 inch wide. we fold it in 1/2 so it fits snuggly on the pcb and just press it on the ends before reflow. id assume the same thing would work on wave but
Electronics Forum | Fri Jan 07 01:28:54 EST 2000 | Dennis O'Donnell
This is a common type of connector. We press them in daily. AMP has a lot of different type of tools and machines available for connectors. We just use a local machine shop to make jigs that fit a standard 2 ton press. It is quicker and les cos
Electronics Forum | Tue Sep 24 14:38:53 EDT 2002 | Jim M.
The EMS company i work for assembles a small PCB board that requires 10 solid press fit pins installed. The pins are Phosphor Bronze, CDA-510 Alloy, Grade A, 3/4 hard with a finish of .00012 min tin/lead over .00005 min nickel.I would like these pla
Electronics Forum | Fri Jul 16 20:17:15 EDT 2004 | cisridn
Hello! I am an Electrical Technician with Filtronic Comtek. I am responsible for all of the Engineering changes and rework done to prototype and pilot run PCB's. My current rework equipment includes: Soldering irons, heat gun, and hot plate. Consid
Electronics Forum | Tue Nov 07 09:26:37 EST 2000 | Peter Barton
Adam, The most common cause for this problem is a variation in the plating thickness of the through holes, particularly if they are Sn/Pb solder levelled PCB's. Most pressfit connectors require a fairly tight control on the diameter of the holes to
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
