Electronics Forum | Thu Apr 18 19:00:06 EDT 2013 | jorge_quijano
Hola.. I have several PCBs with some kind of oxidation, my supplier has told me that there is no problem with that oxidation, it will have no effet on soldering and press fit processes, PCBs were received 1 year ago, but they are well packaged and h
Electronics Forum | Mon Feb 23 05:37:23 EST 2009 | emmanueldavid
Necoleta, PWB Blistering/De-lamination may not be due for Titanium finished threads / holders which is typically being used to draw high Shelf Life of Pallets and even flow across Auto Wave Soldering rails. There is also nothing to suspect on Liquid
Electronics Forum | Thu Feb 27 17:24:34 EST 2003 | pauld
Forgive the non-SMT question. That's why I hate through hole boards. Has anyone ever used Bareco wax on pressfit connectors, and how do you produce a consistent process for its application? Any drawbacks? Background: We have found a design issue with
Electronics Forum | Fri Oct 25 12:23:49 EDT 2002 | yngwie
Hi Experts, I'm facing short problem with BGA at SRT rework in one particular BGA. It is BGA, with a metal piece at the center like a coin. The BGA is located in between two high profile press fit connectors and the short always observed at the si
Electronics Forum | Tue Sep 01 15:37:25 EDT 1998 | Ben Salisbury
| How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks Matt- Find some fairly stiff wire, the correct gau
Electronics Forum | Fri Jun 04 14:00:32 EDT 1999 | Arthur Burdick
Wendy, we at ASG make electric presses for press fit connectors, and have made fixtures for AMP Zpak connectors. give me a call i believe we can help. 561-848-6746 Arthur | Wendy.. | | I found that little nugget a good one from my connector supp
Electronics Forum | Thu Sep 23 22:31:25 EDT 1999 | Dave F
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Thu Oct 14 23:01:48 EDT 1999 | Dennis O'Donnell
With loaded boards, warpage can be removed by placing the assembly in a wave solder conveyor pallet as you would if you were going to wave solder the assembly. Place board and fixture in a Blue M forced air oven at 90 C for 30 minutes. Let cool to r
Electronics Forum | Wed May 19 14:58:31 EDT 1999 | Wendy Casker
John, Thanks for the advice. I spoke with some of the connector suppliers apps guys today and they have what is called "European" style tooling which consists of top and bottom tooling. The board sits on rails and the Bottom tooling receives the pi
Electronics Forum | Fri May 21 15:51:49 EDT 1999 | JohnW
Wendy.. I found that little nugget a good one from my connector suppliers..Oh we have a tool to put it in for u..only catch was the one I needed was �37K ! ! after falling off my seat I went for something like what I described blow..cost about �1K.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830