Electronics Forum | Tue Feb 14 05:01:29 EST 2023 | leeg
Sounds like the brake may have gone?
Electronics Forum | Sat Sep 16 12:49:36 EDT 2006 | magszoo
I'm hoping that someone may be able to shed some light on this error we've been getting on our DEK 265LT printer. Several months ago we began getting a "Rising table position error" after the operator would open the hood to load paste or after changi
Electronics Forum | Wed Jun 22 16:44:20 EDT 2016 | travishemen
It could be the brake for the rising table. I don't remember if it runs on 44 volts but if it is bad it will prevent the table from moving and may blow the fuse.
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Thu Nov 02 17:15:34 EST 2000 | Erdem Bilaloglu
We are using semi-circular land pattern and 0.004" smaller appertures on screen. With stable rising slope (max:2.6degC/sec)we have not experienced any tombstonning so far.
Electronics Forum | Thu Apr 05 08:36:35 EDT 2001 | jmlasserre
use a solder join temperature of 200/210� whatever the pcb used (tin lead coated or osp or gold fash). 2nd ==> to adapt the temerature to the pcb used: - Reflow (200-210�) for tin lead coated pcb's (in this case we have just to reflow the solder
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Fri Apr 30 13:26:10 EDT 2021 | amaliahx
The pandemic has altered people's habits, causing a surge in demand for home electronic devices. This has swept the global chip supply and disrupted automobile manufacturing. The pandemic has led to the global shortage of semiconductors or chips, and
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
| 1 |
winsouce.jpg)
