Electronics Forum | Thu May 07 19:29:40 EDT 2009 | kareal
Hi Davef, Do you means it is natural for tin diffusion to copper trace during SMT process? but I could not detect tin in UHAST T=0 unit, and the tin diffusion was found only in copper trace of C4 cage. Two question: 1) Could you tell me which pr
Electronics Forum | Sat May 02 23:31:06 EDT 2009 | kareal
Thanks davef. The defect always occurred during UHAST reliability, but not find in reflow. The key is that there is tin diffuse to copper trace under solder mask. is it a "normal" board defect and what is the potential risk for device? thanks!
Electronics Forum | Mon Oct 22 15:30:57 EDT 2001 | Basaran
Is there anybody in this forum who is using TI DSP 320C6203 modules for communication devices. I would like to know if anyone has problems with Solder bump- Ni pad interface delamination or problems with signal quality.? Cemal Basaran
Electronics Forum | Tue Oct 23 20:27:06 EDT 2001 | davef
WOW!!! How do people get these coo toys? Comments are: * IPC-7530 is not a specification. It is merely a guideline. [IPC-7530 �Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)�] * What makes you say a 20-micron intermetall
Electronics Forum | Thu Oct 21 16:31:23 EDT 2004 | Tony
I have a component manufacturer that is using Sn/Ag/Cu plating on chip caps and resistors. Does anyone have any information on compatability with Sn/Pb paste. Are any changes in profile required? Is the reliability of the solder joint at risk? Tony
Electronics Forum | Wed Oct 24 11:14:44 EDT 2001 | Cemal Basaran
Dave; Thanks for responsding so fast. here are my answers. 1-WOW!!! How do people get these cool toys? I am with the University at Buffalo Electronic Packaging Lab. http://www.packaging.buffalo.edu We have pretty much everything that is sold on the
Electronics Forum | Tue Apr 11 09:45:45 EDT 2000 | emmanuel
Hi Kc, As recommended by the PBGA supplier, the temperature of the package surface should not exceed 225�C during 10 seconds max so as to avoid popcorn effect. Given that some of products reflow profils are specifiing reflow temperature at 250�C,
Electronics Forum | Mon Nov 28 09:46:24 EST 2005 | pjc
I have waved gold (ENIG) boards. That's a pretty hot pot at 260C, wow. I have used 245C with good results. All other parameters look OK a glance. Well, PCB temp looks a little hot too at 130C before pot. 90-100C is typical for most No-Clean flux. At
Electronics Forum | Wed Oct 24 18:08:02 EDT 2001 | davef
1- DF1: WOW!!! How do people get these cool toys? CB: I am with the University at Buffalo Electronic Packaging Lab. http://www.packaging.buffalo.edu We have pretty much everything that is sold on the market as well as Laser inspection technologies we
Electronics Forum | Thu Oct 08 03:33:50 EDT 1998 | Thomas Blesinger
| | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the remain
