19 rj-45 results

Electronics Forum: rj-45 (Page 1 of 2)

RJ 45 RLC parameters

Electronics Forum | Fri Dec 14 03:49:19 EST 2007 | cobrasv

Friends, Need some help here. Can anyone gimme any info about single line model RLC parameters of an RJ45 connector.

RJ45 location pins and 2 sided assembly problem

Electronics Forum | Sat Oct 26 10:12:32 EDT 2024 | madisreivik

Hello ! Please offer some clever solution for the following problem 2 sided assembly. The side which must be assembled first has 2 SMD RJ45 connectors. They have plastic location pins. Which protrude tru the board, about 0.4mm So, when I want to a

RJ45 1X4 Way Connector

Electronics Forum | Tue Feb 17 01:59:43 EST 2015 | vb7007

Travel Direction Similar Part : http://nz.rs-online.com/web/p/rj45-connectors/8208205/ And we are getting Solder short on every PCB and also additionally Dry joints (leads) on some. Played with Flux adjustments and also Parameter settings for wave,

RJ45 Connector short issue after wave

Electronics Forum | Sat Jun 07 04:01:56 EDT 2008 | carmanah

Hi all, Need advice how to fix RJ45 short issue after wave solder m/c .Few actions taken to resolve this issue but the outcome was inclusive which was 1. Modify wave pallet 2. Change conveyor setting from 0.8meter/minute to 0.7 meter/minute 3. Clear

Reflowing two sided PCBs

Electronics Forum | Sat Oct 26 10:08:31 EDT 2024 | madisreivik

I would (and actually I do :) use 2 different pastes SAC for "simple" side LMPA for "populated" side LMPA has much lower peak temp, so SAC does not remelt and as a result, no glue etc are needed. Yesterday did a board, one side - some 0805 comps a

RJ45 Connector short issue after wave

Electronics Forum | Sat Jun 07 09:13:18 EDT 2008 | beatrice889

You even try out control/cut the connector lead length & turn the wave pallet loading direction?

Wave Solder question

Electronics Forum | Tue May 22 11:26:56 EDT 2012 | rway

Lead spacing is probably an issue here. It would be better if your lead pattern was staggered, like the RJ-45 to the right. It appears there may not be enough flux on this part of the pcb.