Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Mar 23 09:29:58 EST 2006 | Joe
I agree that it's the probably the chain. The links get dirty and can bind up over time. When you pull the chain, check to see that each link rotatates freely with its adjacent link. I bet you'll find one or more links that are binding. This is the s
Electronics Forum | Mon Mar 20 11:48:21 EST 2006 | Chunks
jdengler may be right. Had a 10 zone do the same thing. It was a couple links in the chain.
Electronics Forum | Sat Mar 25 15:27:21 EST 2006 | Mike ZIG
Hi all, What is the best oil to lubricate the chain ? Mike
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Mon Mar 20 09:28:47 EST 2006 | PWH
We just went through this exact same problem on an OmniFlo. We did all the stuff Marc talks about and the problem went away completely. As Marc states, clean the chain guides! You will will see lots of junk near the last zones(s).
