Electronics Forum | Tue Oct 21 08:06:15 EDT 2008 | maheshbs
I have problem in Jot Automation inspection conveyor. The Problem is that the Good board has to go in down side conveyor & Bad board has to go in upside for rejection or rework. It is unable to separate the good & bad boards. Kindly refer the attachm
Electronics Forum | Wed Oct 22 01:14:04 EDT 2008 | maheshbs
Conveyor is installed after AOI machine. After inspecting the board in AOI it sends the signal to the conveyor whether it is Good board or Bad board.
Electronics Forum | Tue Oct 21 13:49:06 EDT 2008 | ccouture
How does the conveyor know if a board is good or bad?
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Sat Aug 11 16:40:04 EDT 2012 | johnyq
We have a Bosch Edge Pro inspection conveyor. We are trying to get information about it. Is Bosch still in the conveyor business. Does anyone know how to contact them? Thanks.
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Jan 27 17:32:51 EST 2016 | billthebuilder
We do High Mix, Low Volume and are looking for the best inline AXI with the criteria of industry-leading automation capabilities. The abilities to program offline, automatic conveyor width adjustment and board alignment are important to us. We want t
Electronics Forum | Tue Oct 05 16:38:51 EDT 2010 | tskim83
Our hole inspector gives this error message “Base Hole Error”. It is a flat conveyor-type hole inspection machine from YAYATech that scans PCBs, with an optic sensor and cameras on top of the belt and a light source on the bottom of the belt. And dur
Electronics Forum | Mon Apr 24 11:44:53 EDT 2017 | emeto
It is good to have: conveyor after SPI(if you don't have SPI should be after the printer), conveyor before the oven(inspection station is better), conveyor after the oven - before your destacker if you have one. The rest of it, depends on how long li
Electronics Forum | Mon May 01 14:18:00 EDT 2017 | tombstonesmt
Printer>SPI>Conveyor>Gate>PNP>Inspection Conveyor>Oven>Stacker (in case the oven gets backed up)>AOI> NG Stacker>End of line Stacker.
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
