Electronics Forum | Mon Nov 03 07:47:47 EST 2008 | jdengler
mickd, I prefer a rail of 7.62mm (0.300"). This alows for the tooling pins and fiducials without any trouble and minimizes the waste. A fiducial of 1mm round with a 1mm clear area around it. Jerry
Electronics Forum | Wed Jul 01 07:51:29 EDT 2009 | wrongway
Hello All We are going to run our frist 0402 parts soon. do I need to go to .005 stencil or will .006 work ? do I need to use a type 4 paste ? pad design does a standard rectangle work or the round pads ? Thanks in advance for any replies.
Electronics Forum | Fri May 28 09:55:36 EDT 2010 | ccouture
What is the humidity level in your facility? We maintain ~40% year round and never have any issues regarding ESD from cover tape peeling.
Electronics Forum | Mon Jun 27 21:28:15 EDT 2011 | samsim
It seems to be no solder paste release at certain stencil opening, you may need to enlarge the stencil opening. By the way what is the area ratio for the opening and how is the shape (round/square/diamond)?
Electronics Forum | Mon Feb 11 04:53:13 EST 2013 | ngineer
I'd like some recommendations on the type / size of quad fiducials to use. I started with a small + on the silkscreen layer, but i think that a via is better, and have been using it. Now i'm considering a round smd pad, but not sure the size. Any
Electronics Forum | Thu Aug 08 08:30:59 EDT 2013 | benreben
Hi, i use saki AOI and he have special algorithm for inspect TH that analyse presence of pin,angle of filet and short above the round of solder...
Electronics Forum | Wed Sep 04 13:25:28 EDT 2013 | charliedci
Try cake decoration websites. They have nice wooden handled, aluminum, rounded 4-5" blades.
Electronics Forum | Tue Oct 06 15:11:09 EDT 2015 | alexvolovich
From what I remember, the round encoder on top of the Zfi head comes preassembled with the shaft. It's made in Germany. I don't remember the manufacturer, but the name and p/n might be on the label.
Electronics Forum | Mon Feb 13 23:05:02 EST 2017 | swestheimer
I have been asked a very good question but have not been able to find a good answer. IPC for both PCB and PCBA refer to the X & Y dimensions to measure warp and twist but how would you determine the warp and twist for a round PCB or PCBA?
Electronics Forum | Thu Apr 19 01:50:49 EDT 2018 | leeg
Whats the best way to joint a broken conveyor drive belt? Ive tried a rubber glue which lasts for a short time and tried touching both sides to an iron tip and then holding together, again with poor results.