Electronics Forum | Wed Mar 03 11:30:18 EST 1999 | dave reese
Are square pads more difficult to wavesolder than round pads? I am referring to a through hole board.
Electronics Forum | Thu Mar 04 12:49:49 EST 1999 | SMTASSY
| Are square pads more difficult to wavesolder than round pads? | I am referring to a through hole board. | Usualy square pads are for indication of pin 1 on a DIP for example. There might be a difference in the capilary affect due to a different su
Electronics Forum | Thu Mar 19 12:22:54 EDT 2009 | mhjohnso
While investigating a routing study for a new bga device, I found the vendor used round 20 mil pads on 0402 decoupling caps.This allows fitting the caps between break out vias on their 1mm pitch BGA. Round pad gives about 8 mils diagonally from pin t
Electronics Forum | Fri Jul 16 14:05:04 EDT 1999 | Jim Blankenhorn
| | | Hi all , | | | | | | We are trying to implement the micro-BGA technology at our plant. I need the clarification to the following points: | | | | | | 1. Is underfill required for micro-BGAs? | | | | | | 2. What type of stencil apertures are t
Electronics Forum | Sat Jan 23 16:31:09 EST 1999 | Steve Gregory
| Hi Everyone, | We plan to build, for reliability/experimental/research purpose some CSPs (namely Tessera microBGA 46-I/O 0/75mm pitch and TI 64 I/O 0/8 mm pitch). the various factors that we plan to evaluate are the reliability and assembly concern
Electronics Forum | Sat Jan 23 17:00:44 EST 1999 | Earl Moon
| | Hi Everyone, | | We plan to build, for reliability/experimental/research purpose some CSPs (namely Tessera microBGA 46-I/O 0/75mm pitch and TI 64 I/O 0/8 mm pitch). the various factors that we plan to evaluate are the reliability and assembly con
Electronics Forum | Wed Mar 20 19:10:43 EST 2002 | rmerk
I would like to know if there are any detailed studies or sources of information regarding the use of round pads vs square pads with chip components (0402 and greater).Thank you.
Electronics Forum | Wed Nov 05 17:36:12 EST 2003 | Stephen
Make sure that the side of the square is the diameter of the pad, That is that the circle is inside the square not that the square is inside the circle. normally the aperatures are smaller than the pad to get gasketing. In this case the idea is to
Electronics Forum | Fri Nov 08 11:10:36 EST 2013 | rgduval
I'm not completely sure what you're asking, but, I can say that I've placed these parts with MyData's and Philips machines. Pick in the center of the part, and place in the center of the outline, and the terminals should line up with the pads on the
Electronics Forum | Thu Aug 30 11:02:51 EDT 2007 | gmoritz
... talking two-lead LEDS with 2.5mm pitch ... Yes. That's what we are working with. > are the LED terminals shape were Square or > the naturally rounded? Some are round. Some are square. One is U-shaped. > Due to different insert rotations,
.gif)
.gif)
