Electronics Forum | Thu Apr 21 17:22:29 EDT 2005 | davef
We prefer epoxy.
Electronics Forum | Thu Apr 21 10:44:35 EDT 2005 | jdumont
Morning all. So today I have been tasked with conformally coating a few of our first run PCBs for a new product line. The problem is that they have already had all the larger caps potted with RTV. Are there any problems with spraying the CC over the
Electronics Forum | Thu Apr 28 11:14:27 EDT 2005 | bbarr
If you apply the RTV after coating, what happens to bond strength since you are now bonding to the coating and not the board? Will the caps still survive vibration and shock? I specify applying RTV before coating for this reason. Am I correct? I als
Electronics Forum | Thu Apr 21 12:35:15 EDT 2005 | jdumont
Well that doesnt sound very promising. What im going to do is make sure these two boards I just coated (with the RTV already cured) will be used in house only. In the future we will do any conformal coating operations before potting with whatever mat
Electronics Forum | Thu Apr 21 11:43:03 EDT 2005 | davef
We understand the problem of trying to coat over RTV. We have seen the same problem with acrylic and urethane coatings not wanting to stick to RTV. Some acrylics seem to be worse than urethane. Since this is a new product, may be you could pot your
Electronics Forum | Fri Apr 22 10:12:14 EDT 2005 | davef
Common RTV does out-gas causing corrosion. NASA allows use of non/low-out-gassing RTV. Try the following companies: * Ablestik Electronic: Materials, 20021 Susana Road, Rancho Dominguez, California 90221 U.S.A., 310-764.4600, F 310-764-2545 * Arlon
Electronics Forum | Thu Apr 16 10:13:32 EDT 2015 | charliedci
Anyone aware of an acrylic conformal coating that is UV curable?
Electronics Forum | Fri Apr 17 05:39:39 EDT 2015 | sarason
Electrolube has one. http://www.electrolube.com/products/conformal-coatings/uvcl/low_non-voc/ Sarason
Electronics Forum | Mon Apr 04 08:45:42 EDT 2005 | jimih280
how does polyurethane used for wood floor coating differ from urethane conformal coatings sold for circuit boards? where can i get uv tracer to put in oil based urethane?
Electronics Forum | Thu Jul 07 06:48:15 EDT 2005 | davef
Alternatives are: * DSCC Columbus continues to maintain the QPL for MIL-I-46058C. [Engineering is unlikely to change.] * Use International Electrotechnical Commission Standard, IEC 61086 - Coatings for loaded printed wire boards (conformal coatings)
