Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
Electronics Forum | Wed Dec 23 22:00:50 EST 1998 | Phillip Hunter
| Many machines now have adaptive pick that helps tune in the pickup as the 0402 part moves around in the pocket. Fuji may have a feature like this, but I think they adapt the pickup in only one axis (by adjusting the feeder rack). Unfortunately th
Electronics Forum | Tue Mar 04 07:23:15 EST 2003 | msivigny
Hello ricardof, To implement Cpk studies on SMT production equipment, you will require highly accurate glass plates, glass component slugs, accurately manufactured stencils and a measurement system to perform X, Y and Theta positional deviations from
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Wed Mar 27 11:30:20 EST 2002 | itempea
Just a question: have you ever tried to transfer programs between 2 identical MPM printers, or between 2 identical CAMALOT Geminis? Well, you'll be surprised to find out that you have to spend 15 to 30 min tweaking them on the second machine. And th
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Thu May 10 10:33:46 EDT 2001 | Eyal Duzy
Genny, I would like to correct part of the things that you were told. As far as I know, X-Ray tools are not positioned as tools to find solder volume simply because it is not a strong point for them. An X-Ray image is either a projection (2D transm
Electronics Forum | Fri May 16 10:06:44 EDT 2003 | pjc
Traceability of raw material, personnel and equipment performance during product manufacture: Tracing raw material is done by recording the material mfg.�s batch-code that they assign during the material�s manufacture. This is everything from the fl
Electronics Forum | Sun Mar 07 08:19:24 EST 1999 | Earl Moon
| | | | | | | | I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. | | | | | | | | Concerning the BGA stuff, I'm getting
| 1 |
winsouce.jpg)
