Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Wed Mar 08 00:52:47 EST 2006 | ____
Your thinking of the FCP6 vs. CP642. The table on the CP642 is different from the FCP6/FCP6E. The speed for the machines is still rated at 40k cph (0.09). The differences from the FCP6 and FCP6E is the Safety Circuits and a few other electrical dif
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Fri Nov 09 05:15:34 EST 2007 | exar
Hi, Inm also kind of new in this matter, I had noticed that the feeder tech before me did not used the correct spare parts. He used to mix all fuji parts as one. I prefer to use silicone lubricant( it wont become sticky) Alfredo Ronda Tyco safety pr
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Wed Mar 13 19:48:31 EDT 2013 | marcelorotofrance
The front door has as security switch, indeed. It works ok. A lever switch for override the door switch is also included from factory. (It don´t look good from the safety point of view but, you know). There is also a presostatic switch on the air reg
Electronics Forum | Tue Apr 01 07:21:16 EDT 2008 | davef
First, your idea of having a safety glass policy is good. The glasses should meet ANSI Z87.1-2003. [Although, ANSI Z87.1-1989 and ANSI Z87.1 are fine for electronic assembly.] Here's a comparison of the 1989 and 2003 standards: http://www.tasco-safet
Electronics Forum | Thu Mar 30 13:27:53 EST 2006 | bvdb
Just before Christmas we bought a used Fuji IP1 cheap. It took us a while but it's been working great for about a month. Yesterday the IP1 stopped after completing a board but before exiting the board out the conveyer. No error message, no alarm be
Electronics Forum | Wed Sep 10 15:37:31 EDT 2008 | scottp
At the risk of painting with too broad a brush: QEs are like seagulls: fly in, make lots of noise, crap all over things, then fly away. Back to the knob turning vs. analysis debate. Part of it may be different industries. We're in the high reliab
