Electronics Forum | Thu Dec 22 18:54:30 EST 2011 | dwoodbury
Hi. We are having constant error messages from a Fuji QP341/MTU9 tray unit. It says there is a safety relay failed to start in prescribed time. Nothing we do seems to fix it, but rebooting enough times and eventually it goes away. We changed relay bo
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Thu Feb 29 13:42:53 EST 2024 | mistrthou
I'd be looking at the safety circuit as a whole. Grab a multimeter and make sure you get a full closed loop back to the safety relay, and see if the safety relay itself didn't go bad.
Electronics Forum | Mon Dec 07 11:33:25 EST 2020 | ecogroup
Getting these errors: No command response from handler (0x1000) .... DpBlockWriteL: TimeOutWait for ACK .... Loading SYSTEM data to DPRAM is failed ..... Failed to create empty document ..... No command response from handler (0xffff) ..... Faile
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Tue Apr 08 08:01:35 EDT 2014 | cyber_wolf
So we had a ringblow pump blow up in our CP642. We replaced it and now we are getting hardware NG errors very intermittently.(2-4 times during and 8 hour shift) I see that the x-motor fan, cam motor fan,and oil cooler are all in this circuit. When i
Electronics Forum | Thu Mar 30 13:27:53 EST 2006 | bvdb
Just before Christmas we bought a used Fuji IP1 cheap. It took us a while but it's been working great for about a month. Yesterday the IP1 stopped after completing a board but before exiting the board out the conveyer. No error message, no alarm be
Electronics Forum | Wed Mar 11 13:18:32 EDT 2009 | smellew
Even if you disable the MTU(see address 1005 to link out E-stop & address 1219 for the safety fence rear) the servo still needs to be replaced. SA6 is the faulty one, i'm sure there are many dealers who could supply you one. if you need further conf
Electronics Forum | Tue Mar 10 14:11:42 EDT 2009 | rodrigo
Ok I checked and here are the results... Z1 11CS3x Green LED on Q1 11cs4x Green LED on Z2 12cs3x Green LED off (This is the relay I mentioned in my original post). Q2 12cs4x Green LED on M1CR4x Green LED off The servopack SA-6 is the one with the
At ZJ-SMT, we provide premium SMT and PCB assembly equipment and components from leading brands such as Panasonic, Yamaha, Fuji, etc.
Equipment Dealer / Broker / Auctions
4th Floor, No.3 Lane 3, Youxi Rd, Youganpu Village, Fenggang Town
Dongguan, China
Phone: 6473897784
