Electronics Forum | Fri Jan 27 20:10:16 EST 2006 | peter
hi guys the scenario is: when placing parts which required maximum speed, the cp6 sometimes missing resistors here and there, when checking part data, everything ok i notice that when the machine switching between high and low transport speed, (eg: r
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Tue Jan 31 03:34:50 EST 2006 | chadnugent79
If you are sure that your part data is correct, have you checked the calibration of Z origin? Are the parts leaving an impression on the paste or is there no indication of an attempted place. How small of resistors are we talking 0402, 0603, 0805?
Electronics Forum | Wed Jan 26 21:23:51 EST 2000 | Dennis
Hello! all Will anybody give me advice for missing componets for 0402, 0603 R or C chips? I am not gonna tell you which machine I use, but from my experience, every p&p machine has possibility for missing component after placing 400 or more componen
Electronics Forum | Thu Jan 27 07:18:14 EST 2000 | Christopher Lampron
Dennis, The solder paste is responsible for holding the component in place pre-reflow. Several things to look at: Is the paste accurately printed on the pad? If not, there may not be enough of the component in contact with the paste to provide adiq
Electronics Forum | Sun Aug 14 22:58:17 EDT 2005 | crishan
Hi All, I would like help in establishing what is a feasible PPM reject rate from a typical SMD line. As a reference an SMD line consists of, solder paste printer, chip component placement, pick and place IC components and reflow. What is a bench
Electronics Forum | Tue Jul 19 12:18:43 EDT 2005 | russ
We have had this problem with one of our machine although it is not a Mydata. We had to reduce the blow off time for these. Our problem was also these same Rnet packages. the part is proabably picked a little off center, then the blow off hits the
Electronics Forum | Tue Jul 30 09:05:08 EDT 2024 | spoiltforchoice
SMT Maestro is long gone from the wider web. You have to beg those of us who have a copy to share a link or find one of the previously shared links in this forum and see if it is still active. Technically this basic requirement is not that difficult
Electronics Forum | Tue May 24 11:31:53 EDT 2022 | joost
We bought a second hand Saki Voyager AOI machine, all the systems seem to be working but I need to import data to start scanning for errors on pcbs. Now we have never worked with an AOI machine and are at a loss What I think I need is: solder past
Electronics Forum | Wed Jul 20 03:10:45 EDT 2011 | umar
I have mount the 8 pcs SEVEN SEGMENT LEDS on the PWB side at SMT Process, after reflow the board test at customer side and facing some issues which is missing segment and also one segment founded dimmers compare to other segment. Data sheet of LEDs
