Electronics Forum | Mon Jan 29 16:04:29 EST 2007 | BillW
Thanks Russ and John, To clarify defects when manufacturing a PCBA, I use (2) groups of defect categories, one for components and one for solder joints. These can be calculated separately or combined A component defect could be: Missing, Miss-alig
Electronics Forum | Mon Nov 20 10:40:35 EST 2006 | SWAG
Thanks Mark and Dave. It sounds like our board design and problem areas are similar to yours, Mark. We talked with our customer about the grid pattern but I'm not sure where we are at with that. In reference to the Tg/Td thread, the material is a
Electronics Forum | Tue Feb 22 05:50:40 EST 2000 | Arulvanan P
Hi, I am in the process of implemeting Through Hole Reflow. 1.I would to know which are the products/Companies that use that use this process. 2. Is there any reference / standard to convince my QA dept. to accept the boards even though there is no
Electronics Forum | Tue Feb 22 05:50:40 EST 2000 | Arulvanan P
Hi, I am in the process of implemeting Through Hole Reflow. 1.I would to know which are the products/Companies that use that use this process. 2. Is there any reference / standard to convince my QA dept. to accept the boards even though there is no
Electronics Forum | Thu May 27 16:23:12 EDT 2004 | davef
Process Trials Procedures. Standard trials are often conducted on reflow ovens by production engineers during product assessment, machine approval or in process set-up. The following trials are also used by machine suppliers during equipment develop
Electronics Forum | Fri May 14 11:17:42 EDT 2004 | Ashok Dhawan
I am having coating adhesion problem with flex circuits. The cover plate material is KAPTON or Poly imide. The conformal coating material used is humiseal 2A64. The boards are cleaned, measuring less than 4 microgram Nacl per sq in. against acceptabl
Electronics Forum | Mon Aug 17 02:57:47 EDT 1998 | Bob Willis
| | Looking for Suppliers of surface mount wetting balance equipment. | Bucky: Section 6 of the ANSI/J-STD-002 specification lists wetting balance suppliers. Dave F I like and continue to use the Multicore system. I have had many ours using the sys
Electronics Forum | Mon May 28 07:30:52 EDT 2001 | bobwillis
Here is a draft visual inspection guide for underfill, please pass this on to the relevant people for any comments or suggestions. I am currently working on the pictures to go with the reference guide. Flip Chip/uBGA Underfill Visual Standards The
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
winsouce.jpg)
