Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw
Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Wed Apr 10 21:47:55 EDT 2024 | ddfreeze
have swapped 2 different boards, can try switching the dram sticks, or ordering new ones. also the cmos battery on the motrola communications battery was dead, put a new one in, was wondering if there was a cmos reset/ jumper?
Electronics Forum | Wed Mar 28 14:09:04 EDT 2007 | realchunks
Wow, you have a screen printer at home? You must be hardcore! Yes, a USB should work.
Electronics Forum | Wed Mar 28 15:34:08 EDT 2007 | mumtaz
Stay on the course! why do you people like to post subjects that do not pertain to smt engineering?!?1
Electronics Forum | Thu Mar 29 04:29:14 EDT 2007 | Rob
Because sometimes it takes just as long to help someone than to tell them to go away.
Electronics Forum | Wed Apr 04 10:51:22 EDT 2007 | goldeneye
Thanks for all your help everyone, soz for posting in the wrong place!
Electronics Forum | Wed Mar 28 09:53:17 EDT 2007 | goldeneye
Hey all, I would like to share my home printer between 2 computers, I have heard that I can do this with a USB switch, can anyone give me some more information on these?
