Electronics Forum | Tue Oct 11 15:21:12 EDT 2005 | Hoss
Sean, If the machines use more than the spec'd 8CFM, are not leaking and work fine otherwise, I wouldn't disqualify them on that basis alone. You may be exceeding the duty cycle rating of your compressor and not necessarily the volume. If Samsung
Electronics Forum | Wed Feb 28 18:51:38 EST 2001 | Darby
Errr, no. But just a month ago I saw what happens to a Samsung CP45FV when dropped from a forklift. We said sayonara, then balled our eyes out.
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Thu Sep 04 09:05:00 EDT 2014 | JB
Hello All. Another question about programming if anyone could help? We are current placing BGA's and it places them fine but we have noticed it doesn't spot when a ball is missing. We have adjusted the settings so it does reliably spot the missing
Electronics Forum | Thu Mar 05 19:44:08 EST 2020 | portersmt
Hello, Was hoping to hear from fellow users of the Samsung/Hanwha SM4xx series. We currently have an SM482 and we were hoping to do some much need maintenance on it. Specifically, we are wanting to clean and grease the X & Y LM rails and Ball Screw
Electronics Forum | Fri Mar 06 22:12:56 EST 2020 | portersmt
Is there any recommendation you'd have when adding grease - how many pumps into the grease adapters would you do? Should you visually see the grease coating the entire ball screw / LM rail?
Electronics Forum | Fri Mar 06 08:51:07 EST 2020 | richardcargill
We have mainly Philips equipment and use Alvania almost everywhere in them. Ball screws/linear rails etc . As has been mentioned, just clean as much of the old grease off as you can, then regrease and put the machine on a warm up cycle. We do this m
Electronics Forum | Fri Jun 19 15:03:15 EDT 2020 | jmelson
OK, I am really happy with the robustness of my CSM84. I wonder how hard it would be to hack up one of these 3-phase machines to run off single-phase power? Mostly, it just feeds a big DC supply for the X-Y servos. 2 heads with ANE should be just FI
Electronics Forum | Tue Sep 19 22:45:19 EDT 2006 | darby
Larry, The Quad is based on the Samsung - yes? If so, here are the final recommended answers from Samsung. All LM guides and bearings, ball splines and rack and pinion use Shell Alvania EP2. Sometimes called LF2. Sometimes called Albania. It's a dar
| 1 |
winsouce.jpg)
