Electronics Forum | Tue Aug 03 03:27:35 EDT 2004 | kent_peterson
You have alot of advantages staying with the Samsung. The CP60 is a great machine. With the removable carts for setting up in advance giving quick change over. Very good price and better service for you than we get here. Their parts teach on these is
Electronics Forum | Thu Aug 08 04:54:35 EDT 2013 | alexeis
Hi, I want to add some clearance to my question that I didn't speak about preparing files for Samsung SMT machines. I am speaking about process of SMT carts preparation (offline) and process of SMT feeder/component replacing when it is on the SMT li
Electronics Forum | Wed Jul 16 06:54:36 EDT 2014 | alexeis
Hi, The answer is very complex depends on the type of machine, the operator's capabilities and process. There are machines that let you perform the above side then stick carts into the machine and produce. Event such a process is the length of a few
Electronics Forum | Wed Mar 29 18:20:07 EST 2006 | LD
We are also a high mix/low volume OEM and are running Samsung CP45's with quick change carts on both sides of the machine. We currently average 12 minutes of internal changeover time per run with an average of 17 changeovers/day for 2 shifts. We ty
Electronics Forum | Sun Apr 13 02:36:06 EDT 2014 | alexeis
Hi, We have system called Setup Center for Samsung that can give a solution to your needs. It loads samsung files, including before and after optimization, and gives you feeder list splitted by machine and side (Front/Rear). Also, you can go over on
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
Electronics Forum | Mon Apr 28 10:42:20 EDT 2003 | lgroves
Herman, I'm betting you will get a lot of response on this one. Frankly, everybody has their favorite machine. The trick is to consider the types and quantitys of boards you will run. Sometimes, it is better to set up a load for several jobs tha
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Fri Jan 05 11:10:05 EST 2018 | andrewnoland17
hello, my colleague ProcEng1 is right. The main > problems are the gears, which easily are stuck > with foil, the shutter, which has to be > lubricated and not bend. Air cylinders on the > machine have to be changed if you have misfeeds > still.
| 1 |
.gif)
