Electronics Forum | Wed Feb 28 01:10:33 EST 2024 | clpassoni
As I have two identical machines, it was easy, it really is the encoder, and as it is integrated into the motor it will be necessary to change the entire unit, or try to repair the encoder.
Electronics Forum | Mon Dec 02 10:33:46 EST 2013 | sarivong0914
Hello all, We have a Samsung CP45FV Neo, and I'm having problems with the operating software. I have a PCB with 2 different rev's. Rev. A boards was programmed to run Vertical. Then Rev.B boards are horizontal but was programmed to run vertical.
Electronics Forum | Wed Aug 03 10:09:27 EDT 2011 | geb
Our Samsung CP45FV Neo is out of warranty, but due for its annual calibration/ service, however we are wondering whether it is really needed. The line only runs for 8 hours a day 5 days per week (including setup), so not heavy usage. The manual does
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Thu Mar 20 04:25:53 EDT 2014 | JB
More questions about programming components. Is there a comprehensive programming guide for these machines? How does "image capture" & "Autoteach" work? we have a few parts that we are struggling with and they seem simple devices? Pics attached.
Electronics Forum | Fri Jun 05 05:54:07 EDT 2015 | JB
What we have found after using the machine for a while is that its difficult to set up most odd / uneven parts. The best way we have found is use the trimmer package and then use the rough check feature, that seems to work well with most things.
Electronics Forum | Sun Oct 25 06:07:15 EDT 2015 | mytronics
We are using a Pick & Place machine with the samsung brand, model CP45FV NEO. We are in need of Calibration tool for the same. If any supplier is having stock, please contact us with the cost
Electronics Forum | Thu Apr 30 02:09:50 EDT 2020 | bukas
Thank you for you reply yernie. This forum is about industrial electronics assembly machines and technologies and not about smartphones. btw, the problem was IF board if anyone was wondering.
Electronics Forum | Fri Aug 26 19:59:02 EDT 2016 | mhanrahan
We've just purchased a CP45FV Neo to replace an ancient Panasonic line. First non-Panasonic placement equipment I've worked on, so learning as I go here. So far it's been pretty straightforward. However, we use some parts that come in QFN or LCC p
