Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Wed Aug 26 07:24:29 EDT 2020 | sarason
Have you tried this solution https://www.ebay.co.uk/itm/SAMSUNG-CP30-VME-10-DPRAM-REV-001-03-I-O-BOARD/173217871888 sarason
Electronics Forum | Sat Aug 22 16:53:32 EDT 2020 | jmelson
I'm trying to diagnose a Quad QSA-30A machine that won't go ready. I have the machine technical drawings, they have overall machine schematics and cable wiring on most of the cables, but that's all. Does anyone have access to the schematics of the
Electronics Forum | Wed Aug 26 15:00:08 EDT 2020 | jmelson
That's a rev 1 board, my machine has a rev 2. I have no idea if they are interchangeable. So, I bought a Rev 2 board from Korea. But, I'm flying pretty blind on this. I have traced the ready button signal to a microprocessor pin on the IO_DPRAM bo
Electronics Forum | Sat May 11 07:23:41 EDT 2002 | Mladen Alexandrov
Can anyone tell me which machine is better - Philips Topaz X or Samsung CP45FV? The machine is for contract manufacturing services with midium volume, high mix boards.
Electronics Forum | Mon Aug 31 15:39:18 EDT 2020 | jmelson
Yes, the rightmost VME board is the IO_DPRAM, and it also handles the front panel buttons and E-stop inputs to the computer(s). So, reseat the connectors on the front of that board. Also, there may be an interface board on the bottom left (called C
Electronics Forum | Mon Dec 02 10:33:46 EST 2013 | sarivong0914
Hello all, We have a Samsung CP45FV Neo, and I'm having problems with the operating software. I have a PCB with 2 different rev's. Rev. A boards was programmed to run Vertical. Then Rev.B boards are horizontal but was programmed to run vertical.
Electronics Forum | Mon Dec 13 11:27:39 EST 2010 | kvael
I have a Samsung CP30V machine that when starting up gives me the error "NO COMMAND RESPONSE FROM HANDLER". Has anyone had this problem. I have replaced the I/O Dpram board, no change.
Electronics Forum | Tue Feb 25 03:32:58 EST 2020 | bukas
hello guys, I got a problem with MAIN START switch on Samsung CP45FV NEO. The switch itself works, and it activates contactors #1-1 #1-2 and #3 but after pressing READY button there is en error msg reporting that MAIN START has not been pressed. Alre
