Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Thu Apr 10 15:19:12 EDT 2014 | superlen
Sarason, I think the OP is wanting this list after the Samsung machine or their EasyOLP program has optimized the feeder list for their particular machine. I think in the menu on the machine (at least on the CP45 series) there is a print feeder lis
Electronics Forum | Wed May 02 09:25:09 EDT 2012 | tbouslog
Our company has recently changed the way our cage gives our SMT Department their parts to try to better control inventory. SMT now instead of recieving reels recieves strips with only 2-20 extra parts depending and the size/cost of the part. Does any
Electronics Forum | Fri Sep 10 09:00:40 EDT 2004 | rlackey
Hi, It should get you at least a 1997 machine, but the age isn't as critical as the UPS level - you want at least 3.2.3. They are good machines & are well built, and at least comparable with any other second user machines (although not in the Fuji/
Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
Electronics Forum | Wed Feb 15 10:37:19 EST 2012 | caerleon
The only way you will be able to measure it is to count the reel before you put it on the machine, count them when they come off and deduct the amount expected to be placed. you will then have the result of attrition on the machine. or.. Pick the p
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Tue Sep 15 14:12:36 EDT 1998 | Justin Medernach
| Unfortunatly there are too many variables to play with that you can't make a general rule for the vibration time. | However, I suggest you increase the vibration time and lower the vibration force ( AC voltage ). For an SO 8, I would use 600 ms for
Electronics Forum | Mon Apr 02 11:57:08 EDT 2007 | realchunks
Well, I thing mowing his lawn will get your farther, but if you insist.... Fids - Fiducial registration seems to be a bear with most machines. Especially now that most boards are shipped form over seas, the quality is all over the map. Plus the fa
Electronics Forum | Mon Mar 18 08:48:58 EDT 2024 | spoiltforchoice
200 unique components across an entire range is nothing, Were we all so lucky we would all leave the inventory permanently loaded on the line. The Manncorp machines are probably your cheapest solution new. These chinese machines with western input