Electronics Forum | Sat Jan 23 05:21:09 EST 2016 | spectrumsmt
Hi Rick, we sell a very good after market recalibration jig which is available to calibrate most makes including Samsung. We also sell nozzles and feeders! Please get in touch or have a look at the website spectrumsmt.com All the best Ian
Electronics Forum | Tue Mar 07 17:31:25 EST 2017 | kahrpr
The mirror should stay open. go to sys setup go to head go t nozzle check settings. that is were the nozzle check is at
Electronics Forum | Thu Mar 23 07:17:30 EDT 2023 | bukas
I have one plate and nozzle if you want dimensions. And fly camera tool.
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Thu Jun 25 03:08:58 EDT 2020 | jmelson
I see some Quad QSA30 machines on an auction site. They are obviously made by Samsung, and look a LOT like, maybe the Smasung CP40. Can anybody give their experience with this model? I was at an auction for a CP45FV machine, and was VERRY impresse
Electronics Forum | Wed Apr 27 04:49:16 EDT 2011 | geb
Hi Does anyone place the Rebel ES? It is the same as a Rebel except it has a raised bit near the edge of the flat area. I normally pick up the Rebel in the flat area using an 0805 style nozzle (Samsung CP45 CN065) but this raised bit makes it unrelia
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Mon Oct 28 15:13:44 EDT 2013 | larrygroves
It will require an alignment. The tools are usually included in the toolbox, one L shaped magnetic tool, a small square glass plate and there is a tool in the nozzle changer. You can buy them seperately if you dont have them. There is a bigger qu
Electronics Forum | Thu Mar 23 04:44:46 EDT 2023 | gwideman
We are looking to obtain (probably make) the calibration tools used in the camera calibration procedures. To that end, any photos and dimensions would be highly appreciated! The set consists of one or two plates and a hat that fits on the up camer
.png)
